Analysis of kerf width in micro-WEDM
- 31 August 2009
- journal article
- research article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 49 (10), 788-792
- https://doi.org/10.1016/j.ijmachtools.2009.04.006
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Slicing, cleaning and kerf analysis of germanium wafers machined by wire electrical discharge machiningJournal of the American Academy of Dermatology, 2009
- Investigation of wire electrical discharge machining of thin cross-sections and compliant mechanismsInternational Journal of Machine Tools and Manufacture, 2005
- Fabrication of high aspect ratio microstructure arrays by micro reverse wire-EDMJournal of Micromechanics and Microengineering, 2005
- A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi methodJournal of the American Academy of Dermatology, 2004
- Using ultra thin electrodes to produce micro-parts with wire-EDMJournal of the American Academy of Dermatology, 2004
- Modelling and analysis of the wire-tool vibration in wire-cut EDMJournal of the American Academy of Dermatology, 2003
- Vibration of wires used in electro-discharge machiningJournal of Sound and Vibration, 2003
- An analysis and optimisation of the geometrical inaccuracy due to wire lag phenomenon in WEDMInternational Journal of Machine Tools and Manufacture, 2003
- Wire vibration, bowing, and breakage in wire electrical discharge machiningJournal of Applied Physics, 2001
- System Identification of Wire Electrical Discharge MachiningCIRP Annals, 1998