Investigation of wire electrical discharge machining of thin cross-sections and compliant mechanisms
- 31 December 2005
- journal article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 45 (15), 1717-1725
- https://doi.org/10.1016/j.ijmachtools.2005.03.003
Abstract
No abstract availableKeywords
This publication has 16 references indexed in Scilit:
- Investigation of the spark cycle on material removal rate in wire electrical discharge machining of advanced materialsInternational Journal of Machine Tools and Manufacture, 2003
- Micro hole machining by conventional penetration electrical discharge machineInternational Journal of Machine Tools and Manufacture, 2003
- Batch mode micro-electro-discharge machiningJournal of Microelectromechanical Systems, 2002
- Thermal stresses due to electrical discharge machiningInternational Journal of Machine Tools and Manufacture, 2002
- Ultrasonic and electric discharge machining to deep and small hole on titanium alloyJournal of the American Academy of Dermatology, 2002
- A thermo-electric model of material removal during electric discharge machiningInternational Journal of Machine Tools and Manufacture, 1999
- An investigation into the actual EDM off-time in SEA machiningJournal of the American Academy of Dermatology, 1998
- Three-Dimensional Micromachining by Machine ToolsCIRP Annals, 1997
- Fracture toughness of commercial magnetsIEEE Transactions on Magnetics, 1996
- Wire Electrical Discharge Machining of Micro-Involute Gears.TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 1994