The distribution of ion energies at the substrate in an asymmetric bi-polar pulsed DC magnetron discharge
Top Cited Papers
- 12 April 2002
- journal article
- Published by IOP Publishing in Plasma Sources Science and Technology
- Vol. 11 (2), 165-174
- https://doi.org/10.1088/0963-0252/11/2/307
Abstract
Using an energy-resolved mass spectrometer and a time-resolved Langmuir probe, the distribution of bombarding ion energies, their fluxes and energy fluxes at a substrate in an asymmetric bi-polar pulsed DC magnetron have been determined. The discharge was operated in Ar at a pressure of 0.53 Pa with a Ti target and pulsed DC frequencies of 100 and 350 kHz with a range of duty cycles (from 50 to 96%). At 100 kHz, the Ar+and Ti+ time-averaged ion energy distribution functions (IEDFs) reveal three peaks, which are at low energy (+ energy spectra show a remnant of the original sputter-neutral energy distribution function. The mid-range ions are produced in the quiescent region of the voltage reverse phase, when the plasma potential is raised globally a few volts above the cathode potential, typically 10-30 V. The high-energy ions are generated in a period of ~0.3 µs, during the discharge voltage overshoot, when the target potential rises to typically over +140 V. However, given the time resolution of the Langmuir probe (0.5 µs), it is not possible to determine if plasma potential is lifted globally to this high potential or only close to the cathode. At 350 kHz, these `fast' ions make up to about a quarter of the total ion flux at the substrate and an upper bound transient power flux of about 2.5 times the maximum delivered in the `on' phase. The total power flux to a substrate in the sustained phase of the discharge is found to increase with frequency and reverse time.This publication has 28 references indexed in Scilit:
- Space and time resolved Langmuir probe measurements in a 100 kHz pulsed rectangular magnetron systemSurface and Coatings Technology, 2001
- Characterisation studies of the pulsed dual cathode magnetron sputtering process for oxide filmsSurface and Coatings Technology, 2001
- Time-resolved Langmuir probe measurements at the substrate position in a pulsed mid-frequency DC magnetron plasmaSurface and Coatings Technology, 2001
- Using pulsed direct current power for reactive sputtering of Al2O3Journal of Vacuum Science & Technology A, 1999
- Ion energy distribution in ionized dc sputtering measured by an energy-resolved mass spectrometerVacuum, 1999
- High-rate reactive DC magnetron sputtering of oxide and nitride superlattice coatingsVacuum, 1998
- Surface modification of powder particles by plasma deposition of thin metallic filmsSurface and Coatings Technology, 1998
- The deposition of aluminium oxide coatings by reactive unbalanced magnetron sputteringSurface and Coatings Technology, 1996
- Pulsed magnetron sputter technologySurface and Coatings Technology, 1993
- Influence of the plasma on substrate heating during low-frequency reactive sputtering of AINJournal of Vacuum Science & Technology A, 1993