Power Supply for a High-Voltage Application
- 9 July 2008
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 23 (4), 1608-1619
- https://doi.org/10.1109/tpel.2008.925153
Abstract
In this paper, the guidelines to design a high-voltage power converter based on the hybrid series parallel resonant topology, PRC-LCC, with a capacitor as output filter are established. As a consequence of the selection of this topology, transformer ratio, and therefore secondary volume, is reduced. The mathematical analysis provides an original equivalent circuit for the steady-state and dynamical behavior of the topology. A new way to construct high-voltage transformers is also proposed, pointing out the advantages and establishing an original method to evaluate the stray components of the transformer before construction. The way to make compatible the characteristics of both, topology and transformer is illustrated in the frame of a practical application. To demonstrate the feasibility of this solution, a high-voltage, high-power prototype is assembled and tested with good performance and similar behavior to the one predicted by the models. Experimental results are shown on this particular.Keywords
This publication has 17 references indexed in Scilit:
- Dynamic and Steady-State Models for the PRC-LCC Resonant Topology With a Capacitor as Output FilterIEEE Transactions on Industrial Electronics, 2007
- Small Size Power Supply for High Voltage ApplicationPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2006
- A Circuit for the Large and Small Signal Dynamic Modeling of the PRC-LCC Resonant Topology with a Capacitor as Output FilterPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2006
- Small-Signal Model of a 5kW High-Output Voltage Capacitive-Loaded Series-Parallel Resonant DC-DC ConverterPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2006
- D-Q models for resonant convertersPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2004
- Auxiliary series resonant converter: a new converter for high-voltage, high-power applicationsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Analysis of a full-bridge LCC-type parallel resonant converter with capacitive output filterPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- An RC load model of parallel and series-parallel resonant DC-DC converters with capacitive output filterIEEE Transactions on Power Electronics, 1999
- An optimized DC-to-DC converter topology for high-voltage pulse-load applicationsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,1994
- Steady-state analysis and design of the parallel resonant converterIEEE Transactions on Power Electronics, 1988