X‐ray acoustic computed tomography with pulsed x‐ray beam from a medical linear accelerator
Open Access
- 18 December 2012
- journal article
- research article
- Published by Wiley in Medical Physics
- Vol. 40 (1), 010701
- https://doi.org/10.1118/1.4771935
Abstract
Purpose: The feasibility of medical imaging using a medical linear accelerator to generate acoustic waves is investigated. This modality, x‐ray acoustic computed tomography (XACT), has the potential to enable deeper tissue penetration in tissue than photoacoustic tomography via laser excitation. Methods: Short pulsed (μs‐range) 10 MV x‐ray beams with dose‐rate of approximately 30 Gy/min were generated from a medical linear accelerator. The acoustic signals were collected with an ultrasound transducer (500 KHz central frequency) positioned around an object. The transducer, driven by a computer‐controlled step motor to scan around the object, detected the resulting acoustic signals in the imaging plane at each scanning position. A pulse preamplifier, with a bandwidth of 20 KHz–2 MHz at −3 dB, and switchable gains of 40 and 60 dB, received the signals from the transducer and delivered the amplified signals to a secondary amplifier. The secondary amplifier had bandwidth of 20 KHz–30 MHz at −3 dB, and a gain range of 10–60 dB. Signals were recorded and averaged 128 times by an oscilloscope. A sampling rate of 100 MHz was used to record 2500 data points at each view angle. One set of data incorporated 200 positions as the receiver moved 360°. The x‐ray generated acoustic image was then reconstructed with the filtered back projection algorithm. Results: The x‐ray generated acoustic signals were detected from a lead rod embedded in a chicken breast tissue. The authors found that the acoustic signal was proportional to the x‐ray dose deposition, with a correlation of 0.998. The two‐dimensional XACT images of the lead rod embedded in chicken breast tissue were found to be in good agreement with the shape of the object. Conclusions: The first x‐ray acoustic computed tomography image is presented. The new modality may be useful for a number of applications, such as providing the location of a fiducial, or monitoring x‐ray dose distribution during radiation therapy. Although much work is needed to improve the image quality of XACT and to explore its performance in other irradiation energies, the benefits of this modality, as highlighted in this work, encourage further study.Keywords
Funding Information
- National Institutes of Health (1R01 CA133474)
- National Institutes of Health (1R21 CA153587)
- National Institutes of Health (1R01 CA133474, 1R21 CA153587)
This publication has 23 references indexed in Scilit:
- In vivo preclinical photoacoustic imaging of tumor vasculature development and therapyJournal of Biomedical Optics, 2012
- Photoacoustic tomography system for noninvasive real-time three-dimensional imaging of epilepsyBiomedical Optics Express, 2012
- A brain tumor molecular imaging strategy using a new triple-modality MRI-photoacoustic-Raman nanoparticleNature Medicine, 2012
- Photoacoustic Tomography: In Vivo Imaging from Organelles to OrgansScience, 2012
- Biomedical photoacoustics beyond thermal expansion using triggered nanodroplet vaporization for contrast-enhanced imagingNature Communications, 2012
- Viscoelasticity imaging of biological tissues with phase-resolved photoacoustic measurementOptics Letters, 2011
- Volumetric real-time multispectral optoacoustic tomography of biomarkersNature Protocols, 2011
- Golden carbon nanotubes as multimodal photoacoustic and photothermal high-contrast molecular agentsNature Nanotechnology, 2009
- Photoacoustic molecular imaging with antibody-functionalized single-walled carbon nanotubes for early diagnosis of tumorJournal of Biomedical Optics, 2009
- Photoacoustic and ultrasonic coimage with a linear transducer arrayOptics Letters, 2004