Machining induced surface integrity in titanium and nickel alloys: A review
Top Cited Papers
- 31 March 2011
- journal article
- review article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 51 (3), 250-280
- https://doi.org/10.1016/j.ijmachtools.2010.11.003
Abstract
No abstract availableKeywords
This publication has 100 references indexed in Scilit:
- An analytical model to predict specific shear energy in high-speed turning of Inconel 718International Journal of Machine Tools and Manufacture, 2009
- A new material model for 2D numerical simulation of serrated chip formation when machining titanium alloy Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2008
- The influence of cutter orientation and workpiece angle on machinability when high-speed milling Inconel 718 under finishing conditionsInternational Journal of Machine Tools and Manufacture, 2007
- Experimental and numerical modelling of the residual stresses induced in orthogonal cutting of AISI 316L steelInternational Journal of Machine Tools and Manufacture, 2006
- White layer formation in hard turning of H13 tool steel at high cutting speeds using CBN toolingInternational Journal of Machine Tools and Manufacture, 2006
- Key improvements in the machining of difficult-to-cut aerospace superalloysInternational Journal of Machine Tools and Manufacture, 2005
- Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting toolsInternational Journal of Machine Tools and Manufacture, 2004
- A review of developments towards dry and high speed machining of Inconel 718 alloyInternational Journal of Machine Tools and Manufacture, 2004
- White layers and thermal modeling of hard turned surfacesInternational Journal of Machine Tools and Manufacture, 1999
- Machining-Induced Residual Stress: Experimentation and ModelingJournal of Manufacturing Science and Engineering, 1999