An analytical model to predict specific shear energy in high-speed turning of Inconel 718
- 31 October 2009
- journal article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 49 (12-13), 979-990
- https://doi.org/10.1016/j.ijmachtools.2009.06.007
Abstract
No abstract availableKeywords
This publication has 31 references indexed in Scilit:
- The effects of the feed rate on the cutting tool stresses in machining of Inconel 718Journal of the American Academy of Dermatology, 2008
- Effect of machining parameters and cutting edge geometry on surface integrity of high-speed turned Inconel 718International Journal of Machine Tools and Manufacture, 2007
- An investigation of cutting forces and surface damage in high-speed turning of Inconel 718Journal of the American Academy of Dermatology, 2007
- The effect of coating material and geometry of cutting tool and cutting speed on machinability properties of Inconel 718 super alloysMaterials & Design (1980-2015), 2007
- Some effects of cutting edge preparation and geometric modifications when turning INCONEL 718™ at high cutting speedsJournal of the American Academy of Dermatology, 2004
- An overview of the machinability of aeroengine alloysJournal of the American Academy of Dermatology, 2003
- MACHINABILITY OF NICKEL-BASED HIGH TEMPERATURE ALLOYSMachining Science and Technology, 2000
- The machinability of nickel-based alloys: a reviewJournal of the American Academy of Dermatology, 1999
- Analytical and experimental study of shear localization in chip formation in orthogonal machiningJournal of Materials Engineering and Performance, 1995
- The Energy Stored in Metal Chips during Orthogonal CuttingJournal of Applied Physics, 1953