Concentrations of mobile source air pollutants in urban microenvironments.
Open Access
- 18 February 2014
- journal article
- research article
- Published by Taylor & Francis Ltd in Journal of the Air & Waste Management Association
- Vol. 64 (7), 743-758
- https://doi.org/10.1080/10962247.2013.872708
Abstract
Human exposures to criteria and hazardous air pollutants (HAPs) in urban areas vary greatly due to temporal-spatial variations in emissions, changing meteorology, varying proximity to sources, as well as due to building, vehicle, and other environmental characteristics that influence the amounts of ambient pollutants that penetrate or infiltrate into these microenvironments. Consequently, the exposure estimates derived from central-site ambient measurements are uncertain and tend to underestimate actual exposures. The Exposure Classification Project (ECP) was conducted to measure pollutant concentrations for common urban microenvironments (MEs) for use in evaluating the results of regulatory human exposure models. Nearly 500 sets of measurements were made in three Los Angeles County communities during fall 2008, winter 2009, and summer 2009. MEs included in-vehicle, near-road, outdoor, and indoor locations accessible to the general public. Contemporaneous 1- to 15-min average personal breathing zone concentrations of carbon monoxide (CO), carbon dioxide (CO2), volatile organic compounds (VOCs), nitric oxide (NO), nitrogen oxides (NOx), particulate matter (2.5) mass, ultrafine particle (UFP; 3) were measured continuously. In-vehicle and inside/outside measurements were made in various passenger vehicle types and in public buildings to estimate penetration or infiltration factors. A large fraction of the observed pollutant concentrations for on-road MEs, especially near diesel trucks, was unrelated to ambient measurements at nearby monitors. Comparisons of ME concentrations estimated using the median ME/ambient ratio versus regression slopes and intercepts indicate that the regression approach may be more accurate for on-road MEs. Ranges in the ME/ambient ratios among ME categories were generally greater than differences among the three communities for the same ME category, suggesting that the ME proximity factors may be more broadly applicable to urban MEs.Keywords
This publication has 34 references indexed in Scilit:
- Evaluation of Passive Samplers for Assessment of Community Exposure to Toxic Air Contaminants and Related PollutantsEnvironmental Science & Technology, 2011
- On-Road Emission Measurements of Reactive Nitrogen Compounds from Three California CitiesEnvironmental Science & Technology, 2010
- Modeling population exposures to outdoor sources of hazardous air pollutantsJournal of Exposure Science & Environmental Epidemiology, 2007
- Controlled generation of black carbon particles from a diffusion flame and applications in evaluating black carbon measurement methodsAtmospheric Environment, 2007
- Measurement of volatile organic compounds inside automobiles†Journal of Exposure Science & Environmental Epidemiology, 2003
- Study of ultrafine particles near a major highway with heavy-duty diesel trafficAtmospheric Environment, 2002
- Photoacoustic spectrometer for measuring light absorption by aerosol: instrument descriptionAtmospheric Environment, 1999
- The MTBE air concentrations in the cabin of automobiles while fuelingJournal of Exposure Science & Environmental Epidemiology, 1999
- The dri thermal/optical reflectance carbon analysis system: description, evaluation and applications in U.S. Air quality studiesAtmospheric Environment. Part A. General Topics, 1993
- Personal Exposure to Respirable Particulates and SulfatesJournal of the Air Pollution Control Association, 1981