Stresses modeling in multilayer semiconductor structures of automobile regulators and predicting the reliability of their operation
Open Access
- 15 September 2020
- journal article
- Published by National University of Science and Technology MISiS in Materials of Electronics Engineering
- Vol. 23 (2), 134-141
- https://doi.org/10.17073/1609-3577-2020-2-134-141
Abstract
The problems of increasing the reliability of microelectromechanical systems are considered on the example of an automobile voltage regulator. A model of the process is proposed and a study of the effect of temperature on the formation of stress fields in semiconductor structures of active elements of the controller is carried out. The studies assumed of a possible reason for the change in the parameters of the regulator due to the appearance of defects in the crystal structure of the semiconductor material in the structures of integrated voltage regulators. For the study, a mathematical model was proposed that describes the behavior of a semiconductor element of a real car voltage regulator. It was found that the distribution of stresses in the structures is uneven and the maximum value of stresses reaches the edges., An increase in temperature gradients in the structures of regulators leads to the formation of dislocations that change the electrical characteristics of devices. As a result of modeling, it has been established that thermoelastic stresses arising in the process of manufacturing and functioning of semiconductor structures of a regulator in regulators of this type can cause a change in the structure of a semiconductor device due to relaxation of elastic stresses at dislocations. in cars. Measures are proposed, including thermostating of the sensitive elements of microelectromechanical structures, which will increase their service life.Keywords
This publication has 10 references indexed in Scilit:
- Mathematical Model of Flat Surface Machining Inaccuracies due to Elastic Strains of Technological SystemMechanical Engineering and Computer Science, 2018
- STANDARD MODEL HETEROSTRUCTURES FOR MICROWAVE DEVICESMaterials of Electronics Engineering, 2018
- Problems of Reliability of Electronic ComponentsMaterials of Electronics Engineering, 2015
- Autonomous load shutdown mechanism as a voltage stabilization method in automotive power netsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2012
- A practical approach for belt slip detection in automotive electric power generation and storage systemPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2010
- Model-Based Fault Detection and Isolation in Automotive Electrical SystemsPublished by ASME International ,2006
- Analytical derivation of a coupled-circuit model of a claw-pole alternator with concentrated stator windingsIEEE Transactions on Energy Conversion, 2002
- Effect of dynamic aging of dislocations on the deformation behavior of extrinsic semiconductorsSemiconductors, 2002
- The statistical theory of dislocation motion in spontaneous locking-unlocking processesPhysics of the Solid State, 2001
- The effect of impurity atoms on the multiplication of edge dislocationsTechnical Physics, 2001