The stability of the variable-density Kelvin–Helmholtz billow
- 10 October 2008
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 612, 237-260
- https://doi.org/10.1017/s0022112008002966
Abstract
We perform a three-dimensional stability analysis of the Kelvin–Helmholtz (KH) billow, developing in a shear layer between two fluids with different density. We begin with two-dimensional simulations of the temporally evolving mixing layer, yielding the unsteady base flow fields. The Reynolds number is 1500 while the Schmidt and Froude numbers are infinite. Then exponentially unstable modes are extracted from a linear stability analysis performed at the saturation of the primary mode kinetic energy. The spectrum of the least stable modes exhibits two main classes. The first class comprises three-dimensional core-centred and braid-centred modes already present in the homogeneous case. The baroclinic vorticity concentration in the braid lying on the light side of the KH billow turns the flow into a sharp vorticity ridge holding high shear levels. The hyperbolic modes benefit from the enhanced level of shear in the braid whereas elliptic modes remain quite insensitive to the modifications of the base flow. In the second class, we found typical two-dimensional modes resulting from a shear instability of the curved vorticity-enhanced braid. For a density contrast of 0.5, the wavelength of the two-dimensional instability is about ten times shorter than that of the primary wave. Its amplification rate competes well against those of the hyperbolic three-dimensional modes. The vorticity-enhanced braid thus becomes the preferred location for the development of secondary instabilities. This stands as the key feature of the transition of the variable-density mixing layer. We carry out a fully resolved numerical continuation of the nonlinear development of the two-dimensional braid-mode. Secondary roll-ups due to a small-scale Kelvin–Helmholtz mechanism are promoted by the underlying strain field and develop rapidly in the compression part of the braid. Originally analysed by Reinoud et al. (Phys. Fluids, vol. 12, 2000, p. 2489) from two-dimensional non-viscous numerical simulations, this instability is shown to substantially increase the mixing.This publication has 32 references indexed in Scilit:
- Fractal Kelvin–Helmholtz breakupsPhysics of Fluids, 2008
- The merger of two-dimensional radially stratified high-Froude-number vorticesJournal of Fluid Mechanics, 2007
- The Rayleigh–Taylor instability of two-dimensional high-density vorticesJournal of Fluid Mechanics, 2005
- Numerical investigation of the formation of three-dimensional structures in stably-stratified mixing layersPhysics of Fluids, 1998
- Three-dimensional shear layers via vortex dynamicsJournal of Fluid Mechanics, 1988
- The onset of turbulence in finite-amplitude Kelvin–Helmholtz billowsJournal of Fluid Mechanics, 1985
- The mixing layer: deterministic models of a turbulent flow. Part 2. The origin of the three-dimensional motionJournal of Fluid Mechanics, 1984
- The two- and three-dimensional instabilities of a spatially periodic shear layerJournal of Fluid Mechanics, 1982
- On density effects and large structure in turbulent mixing layersJournal of Fluid Mechanics, 1974
- On the inviscid instability of the hyperbolictangent velocity profileJournal of Fluid Mechanics, 1964