Residual stress induced by solidification of thermoviscoelastic melts in the postfilling stage
- 1 February 2004
- journal article
- Published by Elsevier BV in Journal of the American Academy of Dermatology
- Vol. 145 (3), 317-324
- https://doi.org/10.1016/j.jmatprotec.2003.07.015
Abstract
No abstract availableKeywords
This publication has 11 references indexed in Scilit:
- Analysis of thermal residual stress in plastic injection moldingJournal of the American Academy of Dermatology, 2000
- Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validationPolymer Engineering & Science, 1998
- Development of a Computer Simulation of SCORIMInternational Polymer Processing, 1996
- Residual thermal stresses in injection molded productsPolymer Engineering & Science, 1996
- On the Simulation of Thermoplastic Injection Moulding ProcessInternational Polymer Processing, 1995
- Solidification of thermoviscoelastic melts. Part I: Formulation of model problemPolymer Engineering & Science, 1995
- A unified simulation of the filling and postfilling stages in injection molding. Part I: FormulationPolymer Engineering & Science, 1991
- Modeling the packing stage in injection molding of thermoplasticsPolymer Engineering & Science, 1988
- Pressure‐Induced densification in injection moldingPolymer Engineering & Science, 1986
- Analysis of the packing stage in injection moldingPolymer Engineering & Science, 1981