Residual stresses, shrinkage, and warpage of complex injection molded products: Numerical simulation and experimental validation
- 1 January 1998
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 38 (1), 21-37
- https://doi.org/10.1002/pen.10162
Abstract
No abstract availableThis publication has 23 references indexed in Scilit:
- Solidification of thermoviscoelastic melts. Part II: Effects of processing conditions on shrinkage and residual stressesPolymer Engineering & Science, 1995
- Solidification of thermoviscoelastic melts. Part I: Formulation of model problemPolymer Engineering & Science, 1995
- Buildup and relaxation of molecular orientation in injection molding. Part I: FormulationPolymer Engineering & Science, 1993
- Buildup and relaxation of molecular orientation in injection molding. Part II: Experimental verificationPolymer Engineering & Science, 1993
- The birefringence problem in optical disk substrates: A modeling approachAIChE Journal, 1989
- Calculation of the temperature field in injection moldingAIChE Journal, 1988
- The Effect of Fountain Flow on Molecular Orientation in Injection MoldingJournal of Rheology, 1988
- Étude du comportement viscoélastique du polycarbonate de bisphénol-A partiellement cristalliséRheologica Acta, 1969
- Dynamic mechanical properties of crystalline, linear polyethyleneJournal of Polymer Science Part A-2: Polymer Physics, 1966
- The Temperature Dependence of Relaxation Mechanisms in Amorphous Polymers and Other Glass-forming LiquidsJournal of the American Chemical Society, 1955