Reactivity of Ni–Al nanocomposites prepared by mechanical activation: A molecular dynamics study
- 8 February 2021
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 129 (6), 065301
- https://doi.org/10.1063/5.0037397
Abstract
High energy ball milling of metallic powders leads to high reactivity in the milled mixture. The reaction is often faster and starts at a lower temperature. However, the mechanisms responsible for this high reactivity are not yet completely understood. The aim of this study is to evaluate one of the possible activating factors of this heightened reactivity: nano-scale mixing of the reagents. Molecular dynamics was used to analyze the role of an amorphous Ni–Al mixing layer, mimicking the powder microstructure after milling, between two Ni layers. The impact of temperature and stoichiometry was investigated in relation to the formation of the -NiAl intermetallic compound. At low temperatures, pre-mixing does not seem to slow down the diffusion of Ni atoms in an amorphous Al region. Homogeneous nucleation was observed in this peculiar milled microstructure. These two phenomena explain why the nano-scale mixing observed experimentally after high energy milling is indeed an activating factor in the reactivity of metallic systems such as Ni–Al.
Keywords
This publication has 40 references indexed in Scilit:
- Tailored Reactivity of Ni+Al Nanocomposites: Microstructural CorrelationsThe Journal of Physical Chemistry C, 2012
- Visualization and analysis of atomistic simulation data with OVITO–the Open Visualization ToolModelling and Simulation in Materials Science and Engineering, 2009
- Development of an interatomic potential for the Ni-Al systemPhilosophical Magazine, 2009
- Thermal Explosion in Al−Ni System: Influence of Mechanical ActivationThe Journal of Physical Chemistry A, 2009
- A simulation study of the mixing, atomic flow and velocity profiles of crystalline materials during slidingWear, 2009
- Forced Chemical Mixing in Alloys Driven by Plastic DeformationPhysical Review Letters, 2005
- Molecular dynamics investigation on the role of sliding interfaces and friction in the formation of amorphous phasesPhysical Review B, 2005
- Role of mechanical activation in SHS synthesis of TiCJournal of Materials Science, 2004
- Molecular dynamics calculation of heat dissipation during sliding frictionInternational Journal of Heat and Mass Transfer, 2003
- Fast Parallel Algorithms for Short-Range Molecular DynamicsJournal of Computational Physics, 1995