Preparation of interconnected highly porous polymeric structures by a replication and freeze‐drying process
- 17 October 2003
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research Part B: Applied Biomaterials
- Vol. 67B (2), 732-740
- https://doi.org/10.1002/jbm.b.10066
Abstract
Three-dimensional degradable porous polymeric structures with high porosities (93–98%) and well-interconnected pore networks have been prepared by freeze-drying polymer solutions in the presence of a leachable template followed by leaching of the template. Templates of the pore network were prepared by fusing sugar or salt particles to form a well-connected structure. The interstices of the template were then filled with a polymer solution (5–15% w/v) in 1,4-dioxane, followed by freeze-drying of the solvent. Subsequent leaching of the sugar template ensures the connectivity of the pore network. The scaffold architecture consists of relatively large interconnected pores modeled after the template and smaller pores resulting from the freeze-drying process. The total porosity of the resultant porous structures is determined by the interstitial space of the leachable template and by the polymer concentration in the freeze-drying solution. The freezing temperature also has an effect on the final morphology of the porous structures. Compared with freeze-drying and combination of freeze-drying /particulate leaching techniques, this method facilitates higher interconnectivity of the scaffolds. Porous structures have been prepared from several relevant polymers in the biomedical and tissue-engineering field: poly(D,L-lactide) (PDLLA), 1000PEOT70PBT30, a segmented poly(ether ester) based on polyethylene oxide and polybutylene terephthalate, and poly(ϵ-caprolactone) (PCL). The mechanical properties of the porous structures prepared by this technique depend on the nature of the polymer, porosity, and the freezing temperature. With porosities in the range of 95–97%, the compression moduli of scaffolds prepared from the different polymers could be varied between 13.0 and 301.5 kPa. © 2003 Wiley Periodicals, Inc. J Biomed Mater Res Part B: Appl Biomater, 67B: 732–740, 2003Keywords
This publication has 34 references indexed in Scilit:
- Copolymers of trimethylene carbonate and ε-caprolactone for porous nerve guides: Synthesis and propertiesJournal of Biomaterials Science, Polymer Edition, 2001
- Mechanical properties of dense polylactic acid structures fabricated by three dimensional printingJournal of Biomaterials Science, Polymer Edition, 1997
- Fabrication of biodegradable polymer scaffolds to engineer trabecular boneJournal of Biomaterials Science, Polymer Edition, 1996
- Tissue EngineeringScience, 1993
- Fabrication and characterization of an asymmetric polyurethane membrane for use as a wound dressingJournal of Applied Biomaterials, 1992
- Tissue Engineering by Cell Transplantation Using Degradable Polymer SubstratesJournal of Biomechanical Engineering, 1991
- Morphological characterization of microcellular carbon foamsJournal of Materials Science, 1991
- Histopathologic observations after short-term implantation of two porous elastomers in dogsBiomaterials, 1981
- Replamineform: A New Process for Preparing Porous Ceramic, Metal, and Polymer Prosthetic MaterialsScience, 1972
- New Porous Biomaterials by Replication of Echinoderm Skeletal MicrostructuresNature, 1971