Status of the McCad geometry conversion tool and related visualization capabilities for 3D fusion neutronics calculations
- 30 March 2013
- journal article
- Published by Elsevier BV in Fusion Engineering and Design
- Vol. 88 (9-10), 2210-2214
- https://doi.org/10.1016/j.fusengdes.2013.02.146
Abstract
No abstract availableThis publication has 8 references indexed in Scilit:
- Neutronic analysis for the IFMIF target and test cell using a new CAD-based geometry modelFusion Engineering and Design, 2012
- Shutdown dose rate analysis for the European TBM system in ITERFusion Engineering and Design, 2012
- Status of the McDeLicious Approach for the D-Li Neutron Source Term Modeling in IFMIF Neutronics CalculationsFusion Science and Technology, 2012
- Integral approach for neutronics analyses of the European test blanket modules in ITERFusion Engineering and Design, 2011
- Present status of the conceptual design of the EU test blanket systemsFusion Engineering and Design, 2011
- Acceleration techniques for the direct use of CAD-based geometry in fusion neutronics analysisFusion Engineering and Design, 2010
- Use of CAD Generated Geometry Data in Monte Carlo Transport Calculations for ITERFusion Science and Technology, 2009
- Development of Monte Carlo automatic modeling functions of MCAM for TRIPOLI-ITER applicationNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2009