On the Behavior of Hot Crack Formation During Solidification in Fe–Ni Alloys
- 5 February 2003
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 5 (1-2), 66-77
- https://doi.org/10.1002/adem.200390011
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- On the mechanism of liquid copper penetration into iron grain boundariesScandinavian Journal of Metallurgy, 2001
- Solidification Mechanism of Unmodified and Strontium Modified Al–Si AlloysMaterials Transactions, JIM, 2000
- A new hot-tearing criterionMetallurgical and Materials Transactions, 1999
- Effect of Vacancies and Alloying Ordering on the Thermodynamics during Solidification ProcessingMaterials Transactions, JIM, 1998
- The Influence of Lattice Defects on the Solidification Process of Al-Cu Alloys.ISIJ International, 1995
- Rapidly solidified ribbons of Fe2C13Cr1SiMo alloys produced by the planar flow melt spinning processMaterials Science and Engineering: A, 1993
- Environmentally assisted cracking: Overview of evidence for an adsorption-induced localised-slip processActa Metallurgica, 1988
- The effect of melt composition on solidification cracking of steel, with particular reference to continuous castingMetallurgical Transactions B, 1982
- The ductility of continuously-cast steel near the melting point—hot tearingMetallurgical Transactions B, 1979
- A first report on deformation-mechanism mapsActa Metallurgica, 1972