Multi-scale analysis of cone penetration test (CPT) in a virtual calibration chamber
- 1 January 2014
- journal article
- Published by Canadian Science Publishing in Canadian Geotechnical Journal
- Vol. 51 (1), 51-66
- https://doi.org/10.1139/cgj-2012-0476
Abstract
A virtual calibration chamber was developed using a three-dimensional (3D) discrete element method (DEM) to perform cone penetration tests (CPTs) on a discrete analogue of Ticino sand. The macroscale response of the DEM model was previously shown to be in good quantitative agreement with that of analogous physical models. In the current study the performance of the model at meso and microscale levels of resolution is examined. The microscale response is examined using particle displacements and contact force distributions. The mesoscale behaviour is examined using stress and strain fields obtained through appropriate averaging and interpolating procedures. Four CPTs are examined at the steady-state penetration stage. The effects of radial boundary conditions, initial stress state, initial average density, and particle rotational inertia are examined. The ability of the micro and mesoscale data to identify and explain the relevant mechanisms underlying the significant differences in the macroscale response of the models is discussed. Comparisons with similar phenomena observed in physical tests are also highlighted.Keywords
This publication has 35 references indexed in Scilit:
- Critical length of force chains and shear band thickness in dense granular materialsActa Geotechnica, 2012
- Cone penetration tests in a virtual calibration chamberGéotechnique, 2011
- Homogeneity and Symmetry in DEM Models of Cone PenetrationPublished by AIP Publishing ,2009
- Discrete element method (DEM) numerical modeling of double-twisted hexagonal meshCanadian Geotechnical Journal, 2008
- Discrete modelling of granular materials and geotechnical problemsEuropean Journal of Environmental and Civil Engineering, 2008
- Analysis of microstructural strain tensors for granular assembliesInternational Journal of Solids and Structures, 2006
- Cone tip resistance in sand: modeling, verification, and applicationsCanadian Geotechnical Journal, 2005
- Numerical modelling of plane strain tests on sands using a particulate approachGéotechnique, 2005
- A discontinuous future for numerical modelling in geomechanics?Geotechnical Engineering, 2001
- Strain Path MethodJournal of Geotechnical Engineering, 1985