Using WECM to remove the recast layer and reduce the surface roughness of WEDM surface
- 1 June 2019
- journal article
- research article
- Published by Elsevier BV in Journal of the American Academy of Dermatology
- Vol. 268, 140-148
- https://doi.org/10.1016/j.jmatprotec.2019.01.016
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (51575442)
This publication has 17 references indexed in Scilit:
- Investigation on Wire Electrochemical Micro Machining of Ni-based Metallic GlassElectrochimica Acta, 2017
- Influence of the WEDM process on the fatigue behavior of Inconel® 718International Journal of Fatigue, 2016
- Parametric analysis of recast layer formation in wire-cut EDM of HSLA steelThe International Journal of Advanced Manufacturing Technology, 2016
- A study of electrodischarge machining–pulse electrochemical machining combined machining for holes with high surface quality on superalloyAdvances in Mechanical Engineering, 2015
- Wire electrochemical machining using reciprocated traveling wireThe International Journal of Advanced Manufacturing Technology, 2014
- Transitions of micro-EDM/SEDCM/micro-ECM milling in low-resistivity deionized waterInternational Journal of Machine Tools and Manufacture, 2013
- Simultaneous micro-EDM and micro-ECM in low-resistivity deionized waterInternational Journal of Machine Tools and Manufacture, 2012
- A review on current research trends in electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2007
- Micro electrical discharge milling using deionized water as a dielectric fluidJournal of Micromechanics and Microengineering, 2007
- A study of EDM and ECM/ECM-lapping complex machining technologyInternational Journal of Machine Tools and Manufacture, 2006