Laser surface alloying of case hardening steel with tungsten carbide and carbon

Abstract

The laser surface alloying process was used to introduce two different alloying materials, tungsten carbide (WC/Co) and carbon, into the molten surface of a case hardening steel (16MnCrS5), to improve its hardness and wear resistance. The chemical composition and the resulting microstructure in the alloyed layers were of particular interest in this investigation, because the strengthening mechanism was strongly dependent upon the type and amount of the alloy material. For laser alloying with carbon the increase in hardness and wear resistance was based on the martensitic transformation in the composition range concerned. For alloying with tungsten carbide it was necessary to consider two different strengthening mechanisms, namely, martensitic transformation and precipitation of carbides. In both cases the grain refinement in the laser affected zone had an additional effect. Resistance to dry abrasive sliding wear was measured using a conventional pin-on-disc wear testing machine. For both alloy materials the wear rate was substantially lower than that of a substrate that had been laser remelted without alloying additions. MST/1556