Cutting edge rounding: An innovative tool wear criterion in drilling CFRP composite laminates
Top Cited Papers
- 31 December 2009
- journal article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 49 (15), 1185-1196
- https://doi.org/10.1016/j.ijmachtools.2009.08.002
Abstract
No abstract availableKeywords
This publication has 40 references indexed in Scilit:
- Drilling of carbon composites using a one shot drill bit. Part II: empirical modeling of maximum thrust forceInternational Journal of Machine Tools and Manufacture, 2006
- Computerized tomography and C-Scan for measuring delamination in the drilling of composite materials using various drillsInternational Journal of Machine Tools and Manufacture, 2005
- The effect of chisel length and associated pilot hole on delamination when drilling composite materialsInternational Journal of Machine Tools and Manufacture, 2003
- Study of delamination in drilling carbon fiber reinforced plastics (CFRP) using design experimentsComposite Structures, 2003
- An approach for development of damage-free drilling of carbon fiber reinforced thermosetsInternational Journal of Machine Tools and Manufacture, 2001
- Machining parameters for an intelligent machining system for composite laminatesInternational Journal of Machine Tools and Manufacture, 2000
- Some experimental investigations in the drilling of carbon fiber-reinforced plastic (CFRP) composite laminatesInternational Journal of Machine Tools and Manufacture, 1997
- On the machining of fiber reinforced plastic (FRP) composite laminatesInternational Journal of Machine Tools and Manufacture, 1995
- On drilling characteristics of fiber-reinforced thermoset and thermoplasticsInternational Journal of Machine Tools and Manufacture, 1992
- Effect of drilling parameters on the finish and mechanical properties of GFRP compositesInternational Journal of Machine Tools and Manufacture, 1990