An Adaptation Approach for Gas Turbine Design-Point Performance Simulation
- 28 September 2005
- journal article
- Published by ASME International in Journal of Engineering for Gas Turbines and Power
- Vol. 128 (4), 789-795
- https://doi.org/10.1115/1.2136369
Abstract
Accurate simulation and understanding of gas turbine performance is very useful for gas turbine users. Such a simulation and performance analysis must start from a design point. When some of the engine component parameters for an existing engine are not available, they must be estimated in order that the performance analysis can be carried out. However, the initially simulated design-point performance of the engine using estimated engine component parameters may give a result that is different from the actual measured performance. This difference may be reduced with better estimation of these unknown component parameters. However, this can become a difficult task for performance engineers, let alone those without enough engine performance knowledge and experience, when the number of design-point component parameters and the number of measurable/target performance parameters become large. In this paper, a gas turbine design-point performance adaptation approach has been developed to best estimate the unknown design-point component parameters and match the available design-point engine measurable/target performance. In the approach, the initially unknown component parameters may be compressor pressure ratios and efficiencies, turbine entry temperature, turbine efficiencies, air mass flow rate, cooling flows, bypass ratio, etc. The engine target (measurable) performance parameters may be thrust and specific fuel consumption for aero engines, shaft power and thermal efficiency for industrial engines, gas path pressures and temperatures, etc. To select, initially, the design point component parameters, a bar chart has been used to analyze the sensitivity of the engine target performance parameters to the design-point component parameters. The developed adaptation approach has been applied to a design-point performance matching problem of an industrial gas turbine engine GE operating in Manx Electricity Authority (MEA), UK. The application shows that the adaptation approach is very effective and fast to produce a set of design-point component parameters of a model engine that matches the actual engine performance very well. Theoretically, the developed techniques can be applied to other gas turbine engines.
Keywords
This publication has 5 references indexed in Scilit:
- Component Map Generation of a Gas Turbine Using Genetic AlgorithmsPublished by ASME International ,2004
- High-Accuracy Matching of Engine Performance Models to Test DataPublished by ASME International ,2003
- A New Scaling Method for Component Maps of Gas Turbine Using System IdentificationPublished by ASME International ,2002
- Optimal Measurement and Health Index Selection for Gas Turbine Performance Status and Fault DiagnosisJournal of Engineering for Gas Turbines and Power, 1992
- Adaptive Simulation of Gas Turbine PerformanceJournal of Engineering for Gas Turbines and Power, 1990