NTM stabilization by alternating O-point EC current drive using a high-power diplexer
Open Access
- 31 August 2016
- journal article
- Published by IOP Publishing in Nuclear Fusion
- Vol. 56 (12), 126001
- https://doi.org/10.1088/0029-5515/56/12/126001
Abstract
At the tokamak ASDEX Upgrade, experiments to stabilize neoclassical tearing modes (NTMs) by electron cyclotron (EC) heating and current drive in the O-points of the magnetic islands were performed. For the first time, injection into the O-points of the revolving islands was performed via a fast directional switch, which toggled the EC power between two launchers synchronously to the island rotation. The switching was performed by a resonant diplexer employing a sharp resonance in the transfer function, and a small frequency modulation of the feeding gyrotron around the slope of the resonance. Thus, toggling of the power between the two outputs of the diplexer connected to two articulating launchers was possible. Phasing and control of the modulation were performed via a set of Mirnov coils and appropriate signal processing. In the paper, technological issues, the design of the diplexer, the tracking of the diplexer resonance to the gyrotron frequency, the generation and processing of control signals for the gyrotron, and the typical performance concerning switching contrast and efficiency are discussed. The plasma scenario is described, and plasma experiments are presented, where the launchers scanned the region of the resonant surface continuously and also where the launchers were at a fixed position near to the q = 1.5-surface. In the second case, complete stabilization of a 3/2 NTM could be reached. These experiments are also seen as a technical demonstration for the applicability of diplexers in large-scale ECRH systems.Keywords
This publication has 27 references indexed in Scilit:
- Real-time beam tracing for control of the deposition location of electron cyclotron wavesFusion Engineering and Design, 2015
- State-of-the-art neoclassical tearing mode control in DIII-D using real-time steerable electron cyclotron current drive launchersNuclear Fusion, 2014
- Control of neoclassical tearing modesNuclear Fusion, 2012
- On the requirements to control neoclassical tearing modes in burning plasmasPlasma Physics and Controlled Fusion, 2010
- Compatibility of ITER scenarios with full tungsten wall in ASDEX UpgradeNuclear Fusion, 2009
- Neoclassical tearing mode control using electron cyclotron current drive and magnetic island evolution in JT-60UNuclear Fusion, 2009
- A fast switch, combiner and narrow-band filter for high-power millimetre wave beamsNuclear Fusion, 2008
- Enhancement of the Stabilization Efficiency of a Neoclassical Magnetic Island by Modulated Electron Cyclotron Current Drive in the ASDEX Upgrade TokamakPhysical Review Letters, 2007
- Quasi-Optics In High Power Millimeter Wave SystemsAIP Conference Proceedings, 2003
- Analysis of the structure of neoclassical tearing modes in ASDEX UpgradePlasma Physics and Controlled Fusion, 2001