Analysis of ultrasonic-assisted drilling of Ti6Al4V
- 20 January 2009
- journal article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 49 (6), 500-508
- https://doi.org/10.1016/j.ijmachtools.2008.12.014
Abstract
No abstract availableKeywords
This publication has 31 references indexed in Scilit:
- Effect of machining parameters in ultrasonic vibration cuttingInternational Journal of Machine Tools and Manufacture, 2008
- A new material model for 2D numerical simulation of serrated chip formation when machining titanium alloy Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2007
- Feasibility study of the ultrasonic vibration assisted drilling of Inconel superalloyInternational Journal of Machine Tools and Manufacture, 2007
- A three-dimensional inverse problem in estimating the applied heat flux of a titanium drilling – Theoretical and experimental studiesInternational Journal of Heat and Mass Transfer, 2007
- Spiral point drill temperature and stress in high-throughput drilling of titaniumInternational Journal of Machine Tools and Manufacture, 2007
- Ultrasonic-assisted drilling of Inconel 738-LCInternational Journal of Machine Tools and Manufacture, 2006
- Analysis of material response to ultrasonic vibration loading in turning Inconel 718Materials Science and Engineering: A, 2006
- Dry drilling of alloy Ti–6Al–4VInternational Journal of Machine Tools and Manufacture, 2005
- Investigation of chip in vibration drillingInternational Journal of Machine Tools and Manufacture, 1998
- Study on the drill skidding motion in ultrasonic vibration microdrillingInternational Journal of Machine Tools and Manufacture, 1994