A variable optical attenuator based on silicon micromechanics
- 1 February 1999
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 11 (2), 233-235
- https://doi.org/10.1109/68.740714
Abstract
In this letter, we describe a variable optical attenuator for single mode fibers. As for its counterparts based on conventional mechanics the micromechanical attenuator operates by moving an obstructing element in the optical beam in order to adjust the light damping. The device is fabricated using the silicon micromachining technology. This allows one to integrate the electrostatic actuator together with the fiber alignment grooves and the obstructing element. With this design, an insertion loss below 1.5 dB was achieved. The response time was below 5 ms and no hysteresis was measured. The maximum attenuation was -57 dB. Backreflection attenuation was below -37 dB.Keywords
This publication has 6 references indexed in Scilit:
- Miniature Fabry-Perot interferometers micromachined in silicon for use in optical fiber WDM systemsPublished by Institute of Electrical and Electronics Engineers (IEEE) ,2002
- Vertical mirrors fabricated by deep reactive ion etching for fiber-optic switching applicationsJournal of Microelectromechanical Systems, 1997
- Megahertz opto-mechanical modulatorSensors and Actuators A: Physical, 1996
- Surface-micromachined free-space fibre-optic switchesElectronics Letters, 1995
- Silicon modulator based on mechanically-active anti-reflection layer with 1 mbit/sec capability for fiber-in-the-loop applicationsIEEE Photonics Technology Letters, 1994
- Electrostatically driven fiber-optic micromechanical on/off switch and its application to subscriber transmission systemsJournal of Lightwave Technology, 1990