A critical inventory of preoperative skull replicas
- 1 September 2013
- journal article
- Published by Royal College of Surgeons of England in The Annals of The Royal College of Surgeons of England
- Vol. 95 (6), 401-404
- https://doi.org/10.1308/003588413x13629960046994
Abstract
Introduction Physical replicas of organs are used increasingly for preoperative planning. The quality of these models is generally accepted by surgeons. In view of the strong trend towards minimally invasive and personalised surgery, however, the aim of this investigation was to assess qualitatively the accuracy of such replicas, using skull models as an example. Methods Skull imaging was acquired for three cadavers by computed tomography using clinical routine parameters. After digital three-dimensional (3D) reconstruction, physical replicas were produced by 3D printing. The facsimilia were analysed systematically and compared with the best gold standard possible: the macerated skull itself. Results The skull models were far from anatomically accurate. Non-conforming rendering was observed in particular for foramina, sutures, notches, fissures, grooves, channels, tuberosities, thin-walled structures, sharp peaks and crests, and teeth. Conclusions Surgeons should be aware that preoperative models may not yet render the exact anatomy of the patient under consideration and are advised to continue relying, in specific conditions, on their own analysis of the native computed tomography or magnetic resonance imaging.This publication has 13 references indexed in Scilit:
- Deformation of Stereolithographically Produced Surgical Guides: An Observational Case Series ReportClinical Implant Dentistry and Related Research, 2012
- Three-Dimensional Printing of Models for Preoperative Planning and Simulation of Transcatheter Valve ReplacementThe Annals of Thoracic Surgery, 2012
- Hepatic Vessel Segmentation for 3D Planning of Liver Surgery: Experimental Evaluation of a New Fully Automatic AlgorithmAcademic Radiology, 2011
- 3D printing based on imaging data: review of medical applicationsInternational Journal of Computer Assisted Radiology and Surgery, 2010
- Novel use of an aerospace selective laser sintering machine for rapid prototyping of an orbital blowout fractureInternational Journal of Oral & Maxillofacial Surgery, 2010
- Computer-Assisted Craniomaxillofacial SurgeryOral and Maxillofacial Surgery Clinics of North America, 2010
- Dimensional error of selective laser sintering, three-dimensional printing and PolyJet™ models in the reproduction of mandibular anatomyJournal of Cranio-Maxillofacial Surgery, 2009
- Rapid Prototyping Technology for Surgeries of the Pediatric Spine and PelvisJournal of Pediatric Orthopaedics, 2007
- Investigating the achievable accuracy of three dimensional printingRapid Prototyping Journal, 2006
- Analysis of errors in medical rapid prototyping modelsInternational Journal of Oral & Maxillofacial Surgery, 2002