Rapid Determination of Plutonium Isotopes in Environmental Samples Using Sequential Injection Extraction Chromatography and Detection by Inductively Coupled Plasma Mass Spectrometry
- 1 September 2009
- journal article
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 81 (19), 8185-8192
- https://doi.org/10.1021/ac901395e
Abstract
This article presents an automated method for the rapid determination of 239Pu and 240Pu in various environmental samples. The analytical method involves the in-line separation of Pu isotopes using extraction chromatography (TEVA) implemented in a sequential injection (SI) network followed by detection of isolated analytes with inductively coupled plasma mass spectrometry (ICP-MS). The method has been devised for the determination of Pu isotopes at environmentally relevant concentrations, whereby it has been successfully applied to the analyses of large volumes/amounts of samples, for example, 100-200 g of soil and sediment, 20 g of seaweed, and 200 L of seawater following analyte preconcentration. The investigation of the separation capability of the assembled SI system revealed that up to 200 g of soil or sediment can be treated using a column containing about 0.70 g of TEVA resin. The analytical results of Pu isotopes in the reference materials showed good agreement with the certified or reference values at the 0.05 significance level. Chemical yields of Pu ranged from 80 to 105%, and the decontamination factors for uranium, thorium, mercury and lead were all above 10(4). The duration of the in-line extraction chromatographic run was <1.5 h, and the proposed setup was able to handle up to 20 samples (14 mL each) in a fully automated mode using a single chromatographic column. The SI manifold is thus suitable for rapid and automated determination of Pu isotopes in environmental risk assessment and emergency preparedness scenarios.Keywords
This publication has 44 references indexed in Scilit:
- Determination of plutonium isotopes in waters and environmental solids: A reviewAnalytica Chimica Acta, 2009
- Critical comparison of radiometric and mass spectrometric methods for the determination of radionuclides in environmental, biological and nuclear waste samplesAnalytica Chimica Acta, 2008
- Isolation of Pu-isotopes from environmental samples using ion chromatography for accelerator mass spectrometry and alpha spectrometryAnalytica Chimica Acta, 2007
- Improved sample preparation method for environmental plutonium analysis by ICP-SFMS and alpha-spectrometryJournal of Radioanalytical and Nuclear Chemistry, 2007
- Environmental monitoring of plutonium at ultratrace level in natural water (Sea of Galilee—Israel) by ICP-SFMS and MC-ICP-MSJournal of Analytical Atomic Spectrometry, 2004
- Separation of plutonium from soil and sediment prior to determination by inductively coupled plasma mass spectrometryJournal of Analytical Atomic Spectrometry, 2003
- Determination of actinides and strontium in fish samples by extraction chromatographyAnalytica Chimica Acta, 2002
- Plutonium determination in mineral soils and sediments by a procedure involving microwave digestion and extraction chromatographyAnalytica Chimica Acta, 2001
- Separation and preconcentration of actinides by extraction chromatography using a supported liquid anion exchanger: application to the characterization of high-level nuclear waste solutionsAnalytica Chimica Acta, 1995
- Measurement of radioactive nuclides in the environmentThe Analyst, 1989