Effects of Inlet Mass Flow Distribution and Magnitude on Reactant Distribution for PEM Fuel Cells
- 20 July 2005
- journal article
- Published by ASME International in Journal of Fuel Cell Science and Technology
- Vol. 3 (1), 45-50
- https://doi.org/10.1115/1.2134736
Abstract
The mass flow distribution and local flow structures that lead to areas of reactant starvation are explored for a small power large active area PEM fuel cell. A numerical model was created to examine the flow distribution for three different inlet profiles; blunt, partially developed, and fully developed. The different inlet profiles represent the various distances between the blower and the inlet to the fuel cell and the state of flow development. The partially and fully developed inlet profiles were found to have the largest percentage of cells that are deficient, 20% at a flow rate of 6.05 g/s. Three different inlet mass flow rates (stoichs) were also examined for each inlet profile. The largest percent of cells deficient in reactants is 27% and occurs at the highest flow rate of 9.1 g/s (3 stoichs) for the partially and fully developed turbulent profiles. In addition to the uneven flow distribution, flow separation occurs in the front four channels for the blunt inlet profile at all flow rates examined. These areas of flow separation lead to localized reactant deficient areas within a channel.Keywords
This publication has 5 references indexed in Scilit:
- Analysis of Flow Maldistribution of Fuel and Oxidant in a PEMFCJournal of Energy Resources Technology, 2004
- Pressure and flow distribution in internal gas manifolds of a fuel-cell stackJournal of Power Sources, 2003
- Flow network analysis application in fuel cellsJournal of Power Sources, 2002
- Distribution of gas flow in internally manifolded solid oxide fuel-cell stacksJournal of Power Sources, 1997
- Fluid dynamic study of fuel cell devices: simulation and experimental validationJournal of Power Sources, 1994