The measurement of lubricant–film thickness using ultrasound
- 8 April 2003
- journal article
- research article
- Published by The Royal Society in Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences
- Vol. 459 (2032), 957-976
- https://doi.org/10.1098/rspa.2002.1018
Abstract
Ultrasound is reflected from a liquid layer between two solid bodies. This reflection depends on the ultrasonic frequency, the acoustic properties of the liquid and solid, and the layer thickness. If the wavelength is much greater than the liquid–layer thickness, then the response is governed by the stiffness of the layer. If the wavelength and layer thickness are similar, then the interaction of ultrasound with the layer is controlled by its resonant behaviour. This stiffness governed response and resonant response can be used to determine the thickness of the liquid layer, if the other parameters are known. In this paper, ultrasound has been developed as a method to determine the thickness of lubricating films in bearing systems. An ultrasonic transducer is positioned on the outside of a bearing shell such that the wave is focused on the lubricant–film layer. The transducer is used to both emit and receive wide–band ultrasonic pulses. For a particular lubricant film, the reflected pulse is processed to give a reflection–coefficient spectrum. The lubricant–film thickness is then obtained from either the layer stiffness or the resonant frequency. The method has been validated using fluid wedges at ambient pressure between flat and curved surfaces. Experiments on the elastohydrodynamic film formed between a sliding ball and a flat surface were performed. Film–thickness values in the range 50–500 nm were recorded, which agreed well with theoretical film–formation predictions. Similar measurements have been made on the oil film between the balls and outer raceway of a deep–groove ball bearing.Keywords
This publication has 11 references indexed in Scilit:
- ADVANCED TECHNIQUESPublished by Elsevier BV ,1997
- A study of the interaction between ultrasound and a partially contacting solid—solid interfaceProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 1996
- The detection of thin embedded layers using normal incidence ultrasoundUltrasonics, 1994
- Simultaneous measurement of the acoustical properties of a thin-layered medium: The inverse problemThe Journal of the Acoustical Society of America, 1994
- Bulk heterogeneous plane waves propagation through viscoelastic plates and stratified media with large values of frequency domainUltrasonics, 1991
- The Measurement and Study of Very Thin Lubricant Films in Concentrated ContactsTribology Transactions, 1991
- Amplitude spectrum method for the measurement of phase velocityUltrasonics, 1989
- A Model for the Influence of Pressure on the Bulk Modulus and the Influence of Temperature on the Solidification Pressure for Liquid LubricantsJournal of Tribology, 1987
- Theoretical and experimental studies of the oil film in lubricated point contactProceedings of the Royal Society of London. Series A - Mathematical and Physical Sciences, 1966
- Measurement of Oil-Film Thickness Between Disks by Electrical ConductivityJournal of Basic Engineering, 1960