Particle size distributions in functionally graded materials fabricated by the centrifugal solid-particle method
- 1 May 2002
- journal article
- Published by Elsevier BV in Composites Science and Technology
- Vol. 62 (6), 881-888
- https://doi.org/10.1016/s0266-3538(02)00023-4
Abstract
No abstract availableKeywords
Funding Information
- Ministry of Education, Culture, Sports, Science and Technology
This publication has 11 references indexed in Scilit:
- Evaluation of three-dimensional orientation of Al3Ti platelet in Al-based functionally graded materials fabricated by a centrifugal casting techniqueActa Materialia, 2001
- Microstructures and wear resistances of hybrid Al–(Al3Ti+Al3Ni) FGMs fabricated by a centrifugal methodIntermetallics, 2001
- Wear behavior of Al-Al3Ti composite manufactured by a centrifugal methodMetallurgical and Materials Transactions A, 1999
- Formation of a graphite-rich zone in centrifugally cast copper alloy graphite compositesJournal of Materials Science, 1998
- Control of composition gradient in a metal-ceramic functionally graded material manufactured by the centrifugal methodComposites Part A: Applied Science and Manufacturing, 1998
- Analysis of thermal residual stress in a thick-walled ring of duralcan-base Al-SiC functionally graded materialMetallurgical and Materials Transactions A, 1996
- Transient thermal analysis of solidification in a centrifugal casting for composite materials containing particle segregationMetallurgical and Materials Transactions B, 1996
- Measurement of Young's modulus and internal friction of an in situ Al-Al3Ni functionally gradient materialJournal of Materials Science, 1994
- Simulation of solidification and temperature in centrifugal casting process.Journal of the Society of Materials Science, Japan, 1991
- The Viscosity of Concentrated Suspensions and SolutionsThe Journal of Chemical Physics, 1952