Impact-Induced Damage of Laminated Graphite/Epoxy Composites Monitored Using Embedded In-Line Fiber Etalon Optic Sensors
- 1 October 1997
- journal article
- Published by SAGE Publications in Journal of Intelligent Material Systems and Structures
- Vol. 8 (10), 829-841
- https://doi.org/10.1177/1045389x9700801003
Abstract
This paper describes the use of fiber optic sensors embedded into laminated graphite/epoxy composites for low velocity impact-induced damage assessment. The sensor system uses in-line fiber etalon (ILFE) sensors interrogated with path-matched differential interferometry (PMDI) and demodulated with a "single channel phase tracker." Uncoated and coated copper ILFE sensors were embedded at the mid-plane of [902/04/OF(O)/04/902] composite plates subjected to transverse impact (The OF(0) denotes an optical fiber orientation of zero degree). The ILFE sensor response was compared to a resistance strain gage bonded to the back side of the specimen and to the load cell mounted on the impactor. The strain measured with the metal coated ILFE sensor and the load cell response were used to plot a hysteresis strain-load curve to assess the impact-induced damage. The result shows that the-1 J impact energy starts to initiate the composite damage, and that the area contained within the hysteresis loop area is approximately proportional to the delamination area evaluated by X-ray radiographs. X-ray NDE indicates that the embedded ILFE sensor does not alter the structural integrity based on the macro-scale observations. In addition, the impact test showed that the sensor embedded in the middle layer had higher survivability than the resistance strain gage bonded to the rear surface of the plate.Keywords
This publication has 11 references indexed in Scilit:
- Multiplexed optical fiber sensors for air frame repair patch monitoringExperimental Mechanics, 1996
- Evaluation of integrated optic modulator-based detection schemes for in-line fiber etalon sensorsJournal of Lightwave Technology, 1995
- Optical fiber sensing technique for impact detection and location in composites and metal specimensSmart Materials and Structures, 1995
- Low Velocity Impact of Optical Fiber Embedded Laminated Graphite/Epoxy Panels. Part I: Macro-ScaleJournal of Composite Materials, 1994
- Thermal plastic metal coatings on optical fiber sensorsPublished by SPIE-Intl Soc Optical Eng ,1991
- Impact detection and location system for smart skins applicationsPublished by SPIE-Intl Soc Optical Eng ,1990
- Structurally integrated fiber optic damage assessment system for composite materialsApplied Optics, 1989
- Impact-Induced Delamination—A View of Bending Stiffness MismatchingJournal of Composite Materials, 1988
- On Low-Velocity Impact Testing of Composite MaterialsJournal of Composite Materials, 1988
- Transverse cracks in glass/epoxy cross-ply laminates impacted by projectilesJournal of Materials Science, 1981