A review of surface roughness generation in ultra-precision machining
Top Cited Papers
- 1 April 2015
- journal article
- review article
- Published by Elsevier BV in International Journal of Machine Tools and Manufacture
- Vol. 91, 76-95
- https://doi.org/10.1016/j.ijmachtools.2015.02.001
Abstract
No abstract availableKeywords
Funding Information
- National Natural Science Foundation of China (51405217, 51275434)
- Youth Science Foundation of Jiangxi Province of China (20142BAB216025)
- Jiangxi Educational Committee of China (GJJ4210)
- Research Grants Council (PolyU 5287/10E)
This publication has 100 references indexed in Scilit:
- A predictive model of the critical undeformed chip thickness for ductile–brittle transition in nano-machining of brittle materialsInternational Journal of Machine Tools and Manufacture, 2013
- Modeling of dynamic characteristic of the aerostatic bearing spindle in an ultra-precision fly cutting machineInternational Journal of Machine Tools and Manufacture, 2010
- A theoretical and experimental investigation of the tool-tip vibration and its influence upon surface generation in single-point diamond turningInternational Journal of Machine Tools and Manufacture, 2010
- Tool wear control in single-crystal diamond cutting of steel by using the ultra-intermittent cutting methodInternational Journal of Machine Tools and Manufacture, 2009
- Effect of plastic side flow on surface roughness in micro-turning processInternational Journal of Machine Tools and Manufacture, 2006
- Effects of the friction coefficient on the minimum cutting thickness in micro cuttingInternational Journal of Machine Tools and Manufacture, 2005
- Characterisation of nanosurface generation in single-point diamond turningInternational Journal of Machine Tools and Manufacture, 2001
- Error compensation in machine tools — a review: Part II: thermal errorsInternational Journal of Machine Tools and Manufacture, 2000
- Development of monitoring system on the diamond tool wearInternational Journal of Machine Tools and Manufacture, 1999
- Precision spindle and bearing error analysisInternational Journal of Machine Tools and Manufacture, 1995