An Experimental Investigation of Thermal Effects in a Cavitating Inducer
- 1 September 2004
- journal article
- Published by ASME International in Journal of Fluids Engineering
- Vol. 126 (5), 716-723
- https://doi.org/10.1115/1.1792278
Abstract
The thermal effects which affect the development of leading edge cavitation in an inducer were investigated experimentally using refrigerant R114. For different operating conditions, the evolution of the cavity length with the cavitation parameter was determined from visualizations. The tests were conducted up to two-phase breeding. The comparison of tests in R114 and in cold water allowed us to estimate the amplitude of the thermodynamic effect. The results show that the B-factor depends primarily upon the degree of development of cavitation but not significantly upon other parameters such as the inducer rotation speed or the fluid temperature, at least in the present domain of investigation. These trends are qualitatively in agreement with the classical entrainment theory. In addition, pressure fluctuations spectra were determined in order to detect the onset of cavitation instabilities and particularly of alternate blade cavitation and rotating cavitation. If the onset of alternate blade cavitation appeared to be connected to a critical cavity length, the results are not so clear concerning the onset of rotating cavitation.Keywords
This publication has 6 references indexed in Scilit:
- Estimation of thermal effects in cavitation of thermosensible liquidsInternational Journal of Heat and Mass Transfer, 1999
- Cavitation And Bubble DynamicsPublished by Oxford University Press (OUP) ,1995
- Correlations of Thermodynamic Effects for Developed CavitationJournal of Fluids Engineering, 1981
- Thermodynamic Effects on Developed CavitationJournal of Fluids Engineering, 1975
- Cavitation Properties of LiquidsJournal of Engineering for Power, 1964
- Thermodynamic Aspects of Cavitation in Centrifugal PumpsJournal of Fluids Engineering, 1956