Fate of nanoparticles during life cycle of polymer nanocomposites
Open Access
- 6 July 2011
- journal article
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 304 (1), 012060
- https://doi.org/10.1088/1742-6596/304/1/012060
Abstract
Nanoparticles are increasingly used in consumer and structural polymeric products to enhance a variety of properties. Under the influence of environmental factors (e.g., ultraviolet, moisture, temperature) and mechanical actions (e.g., scratching, vibrations, abrasion), nanoparticles could potentially release from the products and thus have negative effects on the environment, health and safety. The fate of nanoparticles in polymer nanocomposites during their exposure to UV environment has been investigated. Epoxy polymer containing multi-walled carbon nanotubes (MWCNTs) and silica nanoparticles were studied. Specially-designed cells containing nanocomposite specimens were irradiated with UV radiation between 295 nm and 400 nm. Chemical degradation, mass loss and surface morphology of the epoxy nanocomposites, and release of nanoparticles were measured. Epoxy containing MWCNTs exposed to UV radiation degraded at a much slower rate than the unfilled epoxy or the epoxy/nanosilica composite. Photodegradation of the matrix resulted in substantial accumulation of nanoparticles on the composite surfaces. Silica nanoparticles were found to release into the environment, but MWCNTs formed a dense network on the composite surface, with no evidence of release even after prolonged exposure. Conceptual models for silica nanoparticle release and MWCNT retention on the surface during UV exposure of nanocomposites are presented.Keywords
This publication has 10 references indexed in Scilit:
- Highly dispersed nanosilica–epoxy resins with enhanced mechanical propertiesPolymer, 2008
- Carbon nanotubes introduced into the abdominal cavity of mice show asbestos-like pathogenicity in a pilot studyNature Nanotechnology, 2008
- Reviewing the Environmental and Human Health Knowledge Base of Carbon NanotubesEnvironmental Health Perspectives, 2007
- Nanotube compositesNature, 2007
- Small but strong: A review of the mechanical properties of carbon nanotube–polymer compositesCarbon, 2006
- Nanotechnology: assessing the risksNano Today, 2006
- Radiation resistant polymer–carbon nanotube nanocomposite thin filmsColloids and Surfaces A: Physicochemical and Engineering Aspects, 2005
- Accelerated UV weathering device based on integrating sphere technologyReview of Scientific Instruments, 2004
- Oxidative skeleton breaking in epoxy–amine networksJournal of Applied Polymer Science, 1985
- Photo-oxidation of epoxy resins cured by non-aromatic aminesPolymer Photochemistry, 1981