Surface modification by electrical discharge machining: A review
Top Cited Papers
- 21 April 2009
- journal article
- review article
- Published by Elsevier BV in Journal of the American Academy of Dermatology
- Vol. 209 (8), 3675-3687
- https://doi.org/10.1016/j.jmatprotec.2008.09.032
Abstract
No abstract availableKeywords
This publication has 57 references indexed in Scilit:
- Improvement of surface finish on SKD steel using electro-discharge machining with aluminum and surfactant added dielectricInternational Journal of Machine Tools and Manufacture, 2005
- The effect in EDM of a dielectric of a urea solution in water on modifying the surface of titaniumInternational Journal of Machine Tools and Manufacture, 2005
- Influence of silicon powder-mixed dielectric on conventional electrical discharge machiningInternational Journal of Machine Tools and Manufacture, 2003
- State of the art electrical discharge machining (EDM)International Journal of Machine Tools and Manufacture, 2003
- EDM performance of Cr/Cu-based composite electrodesInternational Journal of Machine Tools and Manufacture, 2003
- Workpiece surface modification using electrical discharge machiningInternational Journal of Machine Tools and Manufacture, 2003
- Surface modification of Al–Zn–Mg alloy by combined electrical discharge machining with ball burnish machiningInternational Journal of Machine Tools and Manufacture, 2002
- Predictions on surface finish in electrical discharge machining based upon neural network modelsInternational Journal of Machine Tools and Manufacture, 2001
- A new method of optimising material removal rate using EDM with copper–tungsten electrodesInternational Journal of Machine Tools and Manufacture, 2000
- Quantification of surface damage of tool steels after EDMInternational Journal of Machine Tools and Manufacture, 1988