Comparison of the size and morphology of UHMWPE wear debris produced by a hip joint simulator under serum and water lubricated conditions
- 31 December 1996
- journal article
- research article
- Published by Elsevier BV in Biomaterials
- Vol. 17 (9), 865-871
- https://doi.org/10.1016/0142-9612(96)83281-9
Abstract
No abstract availableKeywords
This publication has 9 references indexed in Scilit:
- Isolation of predominantly submicron‐sized UHMWPE wear particles from periprosthetic tissuesJournal of Biomedical Materials Research, 1995
- Wear of polyethylene acetabular cups against zirconia femoral heads studied with a hip joint simulatorWear, 1994
- Comparative study of the wear of UHMWPE with zirconia ceramic and stainless steel femoral heads in artificial hip jointsMedical Engineering & Physics, 1994
- The effect of transfer film and surface roughness on the wear of lubricated ultra-high molecular weight polyethyleneClinical Materials, 1993
- Wear of polyethylene acetabular cups against alumina femoral heads: 5 prostheses compared in a hip simulator for 35 million walking cyclesActa Orthopaedica, 1993
- Low wear rate of UHMWPE against zirconia ceramic (Y‐PSZ) in comparison to alumina ceramic and SUS 316L alloyJournal of Biomedical Materials Research, 1991
- Wear of Artificial Joint Materials IIEngineering in Medicine, 1981
- Wear mechanisms for ultrahigh molecular weight polyethylene in the total hip prosthesisJournal of Applied Polymer Science, 1979
- A method for the quantitative recovery of polyethylene wear debris from the simulated service of total joint prosthesesWear, 1978