Surface modification of carbon nanotubes with copper oxide nanoparticles for heat transfer enhancement of nanofluids
Open Access
- 8 January 2018
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 8 (4), 1791-1802
- https://doi.org/10.1039/c7ra10406e
Abstract
Over the last few years, nanoparticles have been used as thermal enhancement agents in many heat transfer based fluids to improve the thermal conductivity of the fluids. Recently, many experiments have been carried out to prepare different types of nanofluids (NFs) showing a tremendous increase in thermal conductivity of the base fluids with the addition of a small amount of nanoparticles. However, little experimental work has been proposed to calculate the flow behaviour and heat transfer of nanofluids and the exact mechanism for the increase in effective thermal conductivity in heat exchangers. This study mainly focuses on the development of nanomaterial composites by incorporating copper oxide nanoparticles (CuO) onto the surfaces of carbon nanotubes (CNTs). The CNT–CuO nanocomposite was used to prepare water-based heat transfer NFs. The morphological surfaces and loading contents of the CNT–CuO nanocomposite were characterized using field emission scanning electron microscopy (FE-SEM), transmission electron microscopy (TEM), X-ray photoelectron spectroscopy (XPS) and thermogravimetric analysis (TGA) while the physical and thermal properties of the water-based nanofluids were characterized using differential scanning calorimetry (DSC), the Mathis TCi system and a viscosity meter for measuring the heat capacity, thermal conductivity and viscosity of the synthesized NFs, respectively. The heat transfer and the pressure drop studies of the NFs were conducted by a horizontal steel tube counter-flow heat exchanger under turbulent flow conditions. The experimental results showed that the developed NFs with different concentrations of modified CNTs (0.01, 0.05 and 0.1 wt%) have yielded a significant increase in specific heat capacity (102% higher than pure water) and thermal conductivity (26% higher than pure water) even at low concentration. The results also revealed that the heat rate of the NF was higher than that of the base liquid (water) and increased with increasing the concentration of nanoparticles. Furthermore, no significant effect of the nanoparticles on the pressure drop of the system was observed.Funding Information
- King Abdulaziz City for Science and Technology (09-NAN758-04)
This publication has 68 references indexed in Scilit:
- Performance comparison of the plate heat exchanger using different nanofluidsExperimental Thermal and Fluid Science, 2013
- Effects of aggregation on the thermal conductivity of alumina/water nanofluidsThermochimica Acta, 2012
- District heating and cooling: Review of technology and potential enhancementsApplied Energy, 2011
- Thermal conductivity measurement and characterization of binary nanofluidsInternational Journal of Heat and Mass Transfer, 2011
- Enhancements of thermal conductivities with Cu, CuO, and carbon nanotube nanofluids and application of MWNT/water nanofluid on a water chiller systemNanoscale Research Letters, 2011
- Spark plasma sintered multi-wall carbon nanotube reinforced aluminum matrix compositesMaterials & Design (1980-2015), 2010
- Experimental investigation of viscosity and specific heat of silicon dioxide nanofluidsMicro & Nano Letters, 2007
- Enhancement of thermal conductivity with Cu for nanofluids using chemical reduction methodInternational Journal of Heat and Mass Transfer, 2006
- Heat transfer of aqueous suspensions of carbon nanotubes (CNT nanofluids)International Journal of Heat and Mass Transfer, 2006
- Conceptions for heat transfer correlation of nanofluidsInternational Journal of Heat and Mass Transfer, 2000