A Novel Technique for Assessing Turbine Cooling System Performance
- 15 November 2010
- journal article
- Published by ASME International in Journal of Turbomachinery
- Vol. 133 (3), 031013
- https://doi.org/10.1115/1.4001232
Abstract
A new experimental technique for the accurate measurement of steady-state metal temperature surface distributions of modern heavily film-cooled turbine vanes has been developed and is described in this paper. The technique is analogous to the thermal paint test but has been designed for fundamental research. The experimental facility consists of an annular sector cascade of high pressure (HP) turbine vanes from a current production engine. Flow conditioning is achieved by using an annular sector of deswirl vanes downstream of the test section, being both connected by a three-dimensionally contoured duct. As a result, a transonic and periodic flow, highly representative of the engine aerodynamic field, is established: Inlet turbulence levels, mainstream Mach and Reynolds numbers, and coolant-to-mainstream total pressure ratio are matched. Since the fully three-dimensional nozzle guide vane (NGV) geometry is used, the correct radial pressure gradient and secondary flow development are simulated and the cooling flow redistribution is engine-realistic. To allow heat transfer measurements to be performed, a mainstream-to-coolant temperature difference (up to 33.5°C) is generated by using two steel-wire mesh heaters, operated in series. NGV surface metal temperatures are measured (between 20°C and 40°C) by wide-band thermochromic liquid crystals. These are calibrated in situ and on a per-pixel basis against vane surface thermocouples, in a heating process that spans the entire color play and during which the turbine vanes can be assumed to slowly follow a succession of isothermal states. Experimental surface distributions of overall cooling effectiveness are presented in this paper. By employing resin vanes of the same geometry and cooling configuration (to implement adiabatic wall thermal boundary conditions) and the transient liquid crystal technique, surface distributions of external heat transfer coefficient and film cooling effectiveness can be acquired. By combining these measurements with those from the metal vanes, the results can be scaled to engine conditions with a good level of accuracy.Keywords
This publication has 15 references indexed in Scilit:
- Gas Turbine Heat Transfer: Ten Remaining Hot Gas Path ChallengesJournal of Turbomachinery, 2006
- On a Novel Annular Sector Cascade TechniqueJournal of Turbomachinery, 2004
- Convective Heat Transfer and Aerodynamics in Axial Flow TurbinesJournal of Turbomachinery, 2001
- Influence of Surface Roughness on Heat Transfer and Effectiveness for a Fully Film Cooled Nozzle Guide Vane Measured by Wide Band Liquid Crystals and Direct Heat Flux GagesJournal of Turbomachinery, 2000
- Turbulent heat transfer measurements using liquid crystalsInternational Journal of Heat and Fluid Flow, 1999
- Effect of Unsteady Wake on Detailed Heat Transfer Coefficient and Film Effectiveness Distributions for a Gas Turbine BladeJournal of Turbomachinery, 1998
- An Experimental Study Heat Transfer in a Large-Scale Turbine Rotor PassageJournal of Turbomachinery, 1994
- Progress towards understanding and predicting heat transfer in the turbine gas pathInternational Journal of Heat and Fluid Flow, 1993
- An Experimental Study of Heat Transfer and Film Cooling on Low Aspect Ratio Turbine NozzlesJournal of Turbomachinery, 1990
- An Experimental Study of Endwall and Airfoil Surface Heat Transfer in a Large Scale Turbine Blade CascadeJournal of Engineering for Power, 1980