Numerical simulation of the heat transfer in amorphous silicon nitride membrane-based microcalorimeters
- 1 October 2003
- journal article
- research article
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 74 (10), 4389-4403
- https://doi.org/10.1063/1.1605498
Abstract
Numerical simulations of the two-dimensional (2D) heat flow in a membrane-based microcalorimeter have been performed. The steady-state isotherms and time-dependent heat flow have been calculated for a wide range of sample and membrane thermal conductivities and heat capacities. In the limit of high internal thermal conductivity and low membrane heat capacity, the sample heat capacity determined using the relaxation method with a single time constant is shown to be exact. The fractional contribution of the square 2D membrane border to the total heat capacity is calculated (∼24%). Analysis of the steady-state isotherms provide the 2D geometric factor (10.33) linking membrane thermal conductance to thermal conductivity, allowing extraction of the thermal conductivity of either the membrane itself or a sample deposited everywhere on the membrane. For smaller internal thermal conductivity and/or larger membrane heat capacity, systematic errors are introduced into the determination of heat capacity and thermal conductivity of a sample analyzed in the standard (single time constant) relaxation method, as has been previously shown for one dimension. These errors are due to both the changing contribution of the membrane border and to deviations from the ideal semiadiabatic approximation of the relaxation method. The errors are here calculated as a function of the ratios of thermal conductivity and heat capacity of sample and membrane. The differential method of measurement in which the sample heat capacity is taken as the difference between a relaxation method measurement with and without the sample is shown to give significantly smaller errors than the absolute errors of a single measurement. Under standard usage, high internal thermal conductivity is guaranteed by use of a thermal conduction layer such as Cu. The systematic error in this case is an underestimate of true sample heat capacity by less than 2%. The simulation was extended to thermal conditions where a single time constant relaxation approximation cannot be used, specifically, for a sample with low thermal conductivity. Because of the highly precise geometry of these micromachined devices, a comparison between measured and simulated steady-state and time-dependent temperatures is demonstrated to allow extraction of the heat capacity and thermal conductivity of this sample with less uncertainty due to elimination of the Cu heat capacity.Keywords
This publication has 23 references indexed in Scilit:
- Critical behavior ofPhysical Review B, 2002
- Enhancement of the electronic contribution to the low-temperature specific heat of an Fe/Cr magnetic multilayerPhysical Review B, 2002
- Specific heat of and thin films for KPhysical Review B, 1999
- Large Magnetic Entropy in Giant Magnetoresistive Amorphous Gadolinium SiliconPhysical Review Letters, 1999
- Specific heat of amorphous rare-earth–transition-metal filmsPhysical Review B, 1998
- Nanocalorimeter for high resolution measurements of low temperature heat capacities of thin films and single crystalsReview of Scientific Instruments, 1997
- A very sensitive microcalorimetry technique for measuring specific heat of μg single crystalsReview of Scientific Instruments, 1997
- Thermodynamic Measurements of Magnetic Ordering in Antiferromagnetic SuperlatticesPhysical Review Letters, 1996
- Measurement of low-temperature specific heatReview of Scientific Instruments, 1983
- Heat Capacity Measurements on Small Samples at Low TemperaturesReview of Scientific Instruments, 1972