Removal of small particles on silicon wafer by laser-induced airborne plasma shock waves
- 1 June 2001
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 89 (11), 6496-6500
- https://doi.org/10.1063/1.1353562
Abstract
It has been found that effective removal of small particles from silicon wafer surfaces can be achieved by laser-induced airborne plasma shock waves initiated above the surface. This process has demonstrated successfully the removal of 1 μm sized tungsten particles from the surface. Tungsten is known to be one of the most difficult particles to remove using conventional laser cleaning techniques employing direct laser irradiation onto the surface. The area cleaned by the shock waves was over ten times larger than that achieved by conventional laser cleaning. This provides an advantage in speed for cleaning large areas. The cleaning efficiency was strongly dependent on the gap distance between the laser focus (where laser-induced sparking takes place) and the surface. The particle removal began to occur with a gap of 6 mm and the removal efficiency increased significantly with decreasing the gap resulting in a complete removal at 2 mm. The basic idea behind this new cleaning technique and how to apply it for the removal of small particles from surfaces are described. Theoretical considerations about adhesion forces of small particles on the surface and laser-induced shock wave generation are carried out to understand this process.Keywords
This publication has 16 references indexed in Scilit:
- A quantitative analysis of single pulse ultraviolet dry laser cleaningJournal of Applied Physics, 1999
- Cleaning of optical surfaces by excimer laser radiationApplied Surface Science, 1996
- Cladding by laser shock processingJournal of Materials Science Letters, 1994
- A thermal detachment mechanism for particle removal from surfaces by pulsed laser irradiationMicroelectronic Engineering, 1993
- Laser-cleaning techniques for removal of surface particulatesJournal of Applied Physics, 1992
- A thermo-mechanical model for laser ablationJournal of Applied Physics, 1991
- Physical study of laser-produced plasma in confined geometryJournal of Applied Physics, 1990
- Impulse coupling to targets in vacuum by KrF, HF, and CO2 single-pulse lasersJournal of Applied Physics, 1988
- Laser generation of high-amplitude stress waves in materialsJournal of Applied Physics, 1979
- Application of lasers to the production of high-temperature and high-pressure plasmaNuclear Fusion, 1968