Recent advances in non-precious metal catalysis for oxygen-reduction reaction in polymer electrolyte fuelcells
Top Cited Papers
- 18 October 2010
- journal article
- perspective
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 4 (1), 114-130
- https://doi.org/10.1039/c0ee00011f
Abstract
Hydrogen produced from water and renewable energy could fuel a large fleet of proton-exchange-fuel-cell vehicles in the future. However, the dependence on expensive Pt-based electrocatalysts in such fuel cells remains a major obstacle for a widespread deployment of this technology. One solution to overcome this predicament is to reduce the Pt content by a factor of ten by replacing the Pt-based catalysts with non-precious metal catalysts at the oxygen-reducing cathode. Fe- and Co-based electrocatalysts for this reaction have been studied for over 50 years, but they were insufficiently active for the high efficiency and power density needed for transportation fuel cells. Recently, several breakthroughs occurred that have increased the activity and durability of non-precious metal catalysts (NPMCs), which can now be regarded as potential competitors to Pt-based catalysts. This review focuses on the new synthesis methods that have led to these breakthroughs. A modeling analysis is also conducted to analyze the improvements required from NPMC-based cathodes to match the performance of Pt-based cathodes, even at high current density. While no further breakthrough in volume-specific activity of NPMCs is required, incremental improvements of the volume-specific activity and effective protonic conductivity within the fuel-cell cathode are necessary. Regarding durability, NPMCs with the best combination of durability and activity result in ca. 3 times lower fuel cell performance than the most active NPMCs at 0.80 V. Thus, major tasks will be to combine durability with higher activity, and also improve durability at cell voltages greater than 0.60 V.Keywords
This publication has 80 references indexed in Scilit:
- Iron porphyrin-based cathode catalysts for polymer electrolyte membrane fuel cells: Effect of NH3 and Ar mixtures as pyrolysis gases on catalytic activity and stabilityElectrochimica Acta, 2010
- Studies of oxygen reduction reaction active sites and stability of nitrogen-modified carbon composite catalysts for PEM fuel cellsElectrochimica Acta, 2010
- Iron porphyrin-based cathode catalysts for PEM fuel cells: Influence of pyrolysis gas on activity and stabilityElectrochimica Acta, 2009
- Fe/N/C non-precious catalysts for PEM fuel cells: Influence of the structural parameters of pristine commercial carbon blacks on their activity for oxygen reductionElectrochimica Acta, 2008
- Average turn-over frequency of O2 electro-reduction for Fe/N/C and Co/N/C catalysts in PEFCsElectrochimica Acta, 2007
- Non-metal Catalysts for Dioxygen Reduction in an Acidic ElectrolyteCatalysis Letters, 2006
- Oxygen reduction by Fe-based catalysts in PEM fuel cell conditions: Activity and selectivity of the catalysts obtained with two Fe precursors and various carbon supportsElectrochimica Acta, 2006
- Fe-based catalysts for the reduction of oxygen in polymer electrolyte membrane fuel cell conditions: determination of the amount of peroxide released during electroreduction and its influence on the stability of the catalystsElectrochimica Acta, 2003
- Heat-treated iron and cobalt tetraphenylporphyrins adsorbed on carbon black: Physical characterization and catalytic properties of these materials for the reduction of oxygen in polymer electrolyte fuel cellsElectrochimica Acta, 1996
- On the effect of a heat treatment on the structure of carbon-supported metalloporphyrins and phthalocyaninesElectrochimica Acta, 1988