A myoelectrically based dynamic three-dimensional model to predict loads on lumbar spine tissues during lateral bending

Abstract

This work describes a dynamic model of the low back that incorporates extensive anatomical detail of the musculo-ligamentous-skeletal system to predict the load time histories of individual tissues. The dynamic reaction moment about L4/L5 was determined during lateral bending from a linked-segment model. This reaction moment was partitioned into restorative components provided by the disc, ligament strain, and active-muscle contraction using a second model of the spine that incorporated a detailed representation of the anatomy. Muscle contraction forces were estimated using both information from surface electromyograms, collected from 12 sites, and consideration of the modulating effects of muscle length, cross-sectional area and passive elasticity. This modelling technique is sensitive to the different ways in which individuals recruit their musculature to satisfy moment constraints. Time histories of muscle forces are provided. High muscle loads are consistent with the common clinical observation of muscle strain often produced by load handling. Furthermore, the coactivation measured in muscles on both sides of the trunk suggests that muscles are recruited to satisfy the lateral bending reaction torque in addition to performing other mechanical roles such as spine stabilization. If an estimate of the intervertebral joint compression is desired for assessment of lateral bends in industry, then a single equivalent lateral muscle with a moment arm of approximately 3.0-4.0 cm would conservatively capture the effects of muscle co-contraction quantified in this study.