The Influence of Shrouded Stator Cavity Flows on Multistage Compressor Performance
- 1 July 1999
- journal article
- Published by ASME International in Journal of Turbomachinery
- Vol. 121 (3), 486-497
- https://doi.org/10.1115/1.2841341
Abstract
Experiments were performed on a low-speed multistage axial-flow compressor to assess the effects of shrouded stator cavity flows on aerodynamic performance. Five configurations, which involved systematic changes in seal-tooth leakage rates and/or elimination of the shrouded stator cavities, were tested. Rig data indicate increasing seal-tooth leakage substantially degraded compressor performance. For every 1 percent increase in seal-tooth clearance-to-span ratio, the decrease in pressure rise was 3 percent and the reduction in efficiency was 1 point. These observed performance penalties are comparable to those commonly reported for rotor and cantilevered stator tip clearance variations. The performance degradation observed with increased leakage was brought about in two distinct ways. First, increasing seal-tooth leakage directly spoiled the near-hub performance of the stator row in which leakage occurred. Second, the altered stator exit flow conditions, caused by increased leakage, impaired the performance of the next downstream stage by decreasing the work input of the rotor and increasing total pressure loss of the stator. These trends caused the performance of downstream stages to deteriorate progressively. Numerical simulations of the test rig stator flow field were also conducted to help resolve important fluid mechanic details associated with the interaction between the primary and cavity flows. Simulation results show that fluid originating in the upstream cavity collected on the stator suction surface when the cavity tangential momentum was low and on the pressure side when it was high. The convection of cavity fluid to the suction surface was a mechanism that reduced stator performance when leakage increased.Keywords
This publication has 10 references indexed in Scilit:
- 1995 ASME Gas Turbine Award Paper: Development and Application of a Multistage Navier–Stokes Flow Solver: Part II—Application to a High-Pressure Compressor DesignJournal of Turbomachinery, 1998
- The Effect of Hub Leakage Flow on Two High Speed Axial Flow Compressor RotorsPublished by ASME International ,1997
- Parameterized study of high-speed compressor seal cavity flowPublished by American Institute of Aeronautics and Astronautics (AIAA) ,1996
- A PC program for estimating measurement uncertainty for aeronautics test instrumentationPublished by American Institute of Aeronautics and Astronautics (AIAA) ,1995
- Engine seal technology requirements to meet NASA's Advanced Subsonic Technology program goalsPublished by American Institute of Aeronautics and Astronautics (AIAA) ,1994
- Secondary Flow, Turbulent Diffusion, and Mixing in Axial-Flow CompressorsJournal of Turbomachinery, 1987
- Using Uncertainty Analysis in the Planning of an ExperimentJournal of Fluids Engineering, 1985
- Spanwise Mixing in Axial-Flow TurbomachinesJournal of Engineering for Power, 1982
- Gas Path Sealing in Turbine EnginesA S L E Transactions, 1980
- Some shrouding and tip clearance effects in axial flow compressors1International Shipbuilding Progress, 1958