Microstructure Characterization and Mechanical Properties of Stainless Steel Clad Plate
Open Access
- 8 February 2019
- Vol. 12 (3), 509
- https://doi.org/10.3390/ma12030509
Abstract
In this study the microstructure and mechanical properties of stainless steel clad plate are researched. Due to element diffusion (Fe, Cr, Ni, Mn), a 20 μm thick diffusion layer is formed between stainless steel and carbon steel clad plate. The diffusion layer has a stable mechanical performance without obvious grain microstructure, and its internal mechanical properties show a graded change in the thickness direction. This is beneficial to a strong bond between stainless steel and carbon steel and the stable transition of mechanical performance in the thickness direction, as well as further carbon diffusion changes in the microstructure and mechanical properties near the diffusion layer of clad plate. Carburization stainless steel with a thickness of 150 μm is formed in the stainless steel side and decarburization carbon steel with a thickness of 80 μm is formed in the carbon steel side.Keywords
Funding Information
- National Natural Science Foundation of China (51575040)
This publication has 22 references indexed in Scilit:
- Fabrication of a thick copper-stainless steel clad plate for nuclear fusion equipment by explosive weldingFusion Engineering and Design, 2018
- Effect of heat treatment on the mechanical properties of copper clad steel platesVacuum, 2018
- Suppression of edge cracking and improvement of ductility in high borated stainless steel composite plate fabricated by hot-roll-bondingMaterials Science and Engineering: A, 2018
- Mechanical bonding properties and interfacial morphologies of austenitic stainless steel clad platesMaterials Science and Engineering: A, 2017
- A simulation study on the multi-pass rolling bond of 316L/Q345R stainless clad plateAdvances in Mechanical Engineering, 2015
- A novel reduction-bonding process to fabricate stainless steel clad plateJournal of Alloys and Compounds, 2014
- Microstructures and mechanical properties of Mg/Mg and Mg/Al/Mg laminated composites prepared via warm roll bondingMaterials Science and Engineering: A, 2012
- Effect of annealing on the interface microstructure and mechanical properties of a STS–Al–Mg 3-ply clad sheetMaterials Science and Engineering: A, 2012
- An investigation on the explosive cladding of 316L stainless steel-din-P355GH steelJournal of the American Academy of Dermatology, 2004
- Microstructure–property relationship in explosively welded duplex stainless steel–steelMaterials Science and Engineering: A, 2003