On the delamination and crack formation in a thin wall fabricated using laser solid freeform fabrication process: An experimental–numerical investigation
- 22 July 2009
- journal article
- Published by Elsevier BV in Optics and Lasers in Engineering
- Vol. 47 (11), 1160-1168
- https://doi.org/10.1016/j.optlaseng.2009.06.010
Abstract
No abstract availableKeywords
This publication has 21 references indexed in Scilit:
- A 3D dynamic numerical approach for temperature and thermal stress distributions in multilayer laser solid freeform fabrication processOptics and Lasers in Engineering, 2007
- Rapid manufacturing of metal components by laser formingInternational Journal of Machine Tools and Manufacture, 2006
- Effect of thermal misfit stress on crack deflection at planar interfaces in layered systemsComposites Science and Technology, 2006
- Laser rapid manufacturing of Colmonoy-6 componentsOptics and Lasers in Engineering, 2005
- Epitaxial repair and in situ damage assessment for turbine bladesProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2005
- Adaptive fuzzy sliding-mode control for the Ti6Al4V laser alloying processThe International Journal of Advanced Manufacturing Technology, 2004
- The effect of laser pulse width on multiple-layer 316L steel clad microstructure and surface finishApplied Surface Science, 2003
- An investigation of the effect of pulse frequency in laser multiple-layer cladding of stainless steelApplied Surface Science, 2003
- Sensing, modeling and control for laser-based additive manufacturingInternational Journal of Machine Tools and Manufacture, 2003
- Residual stress-induced warping in direct metal solid freeform fabricationInternational Journal of Mechanical Sciences, 2002