Finite Element Analysis of Creep Damage Behavior Near the Cavity on Bimaterial Interface
- 1 November 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Key Engineering Materials
- Vol. 324-325, 951-954
- https://doi.org/10.4028/www.scientific.net/kem.324-325.951
Abstract
Fracture along an interface between materials plays a major role in failure of material. In this investigation, finite element calculations with Kachanov–Rabotnov damage law were carried out to study the creep damage distribution near the interface cavity in bimaterial specimens. The specimens with central hole were divided into three types. The material parameters of K-R law used in this paper were chosen for a brittle material and ductile material. All calculations were performed under four load cases. Due to the difference between elastic moduli of the bounded materials, the elastic stress field as a function of the Young’s modulus ratio (R=E1/E2) was determined. At the same time, the influence of model type on elastic stress distribution near the cavity was considered. Under the same conditions, the material with larger modulus is subjected to larger stress. The creep damage calculations show that the location of the maximum damage is different for each model. The distributions of creep damage for all three models are dependent on the material properties and load cases.Keywords
This publication has 6 references indexed in Scilit:
- Analysis of an elliptical crack parallel to a bimaterial interface under tensionMechanics of Materials, 2003
- Influence of interface on fatigue threshold values in elastic bimaterialsComputational Materials Science, 2003
- Fatigue crack propagation normal to a plasticity mismatched bimaterial interfaceMaterials Science and Engineering: A, 2003
- The influence of plasticity mismatch on the growth and coalescence of spheroidal voids on the bimaterial interfaceInternational Journal of Plasticity, 2002
- A numerical study of parameters controlling stress redistribution in circular notched specimens during creepThe Journal of Strain Analysis for Engineering Design, 1993
- Introduction to continuum damage mechanicsMechanics of Elastic Stability, 1986