A Review of Water Management in Polymer Electrolyte Membrane Fuel Cells
Top Cited Papers
Open Access
- 17 November 2009
- Vol. 2 (4), 1057-1106
- https://doi.org/10.3390/en20401057
Abstract
At present, despite the great advances in polymer electrolyte membrane fuel cell (PEMFC) technology over the past two decades through intensive research and development activities, their large-scale commercialization is still hampered by their higher materials cost and lower reliability and durability. In this review, water management is given special consideration. Water management is of vital importance to achieve maximum performance and durability from PEMFCs. On the one hand, to maintain good proton conductivity, the relative humidity of inlet gases is typically held at a large value to ensure that the membrane remains fully hydrated. On the other hand, the pores of the catalyst layer (CL) and the gas diffusion layer (GDL) are frequently flooded by excessive liquid water, resulting in a higher mass transport resistance. Thus, a subtle equilibrium has to be maintained between membrane drying and liquid water flooding to prevent fuel cell degradation and guarantee a high performance level, which is the essential problem of water management. This paper presents a comprehensive review of the state-of-the-art studies of water management, including the experimental methods and modeling and simulation for the characterization of water management and the water management strategies. As one important aspect of water management, water flooding has been extensively studied during the last two decades. Herein, the causes, detection, effects on cell performance and mitigation strategies of water flooding are overviewed in detail. In the end of the paper the emphasis is given to: (i) the delicate equilibrium of membrane drying vs. water flooding in water management; (ii) determining which phenomenon is principally responsible for the deterioration of the PEMFC performance, the flooding of the porous electrode or the gas channels in the bipolar plate, and (iii) what measures should be taken to prevent water flooding from happening in PEMFCs.Keywords
This publication has 261 references indexed in Scilit:
- Microporous layer for water morphology control in PEMFCInternational Journal of Heat and Mass Transfer, 2009
- Measurement of flow maldistribution in parallel channels and its application to ex-situ and in-situ experiments in PEMFC water management studiesInternational Journal of Heat and Mass Transfer, 2009
- Preparation of water management layer and effects of its composition on performance of PEMFCsEnergy Conversion and Management, 2008
- Reactants flow behavior and water management for different current densities in PEMFCInternational Journal of Heat and Mass Transfer, 2008
- Local current density and water management in PEMFCsInternational Journal of Heat and Mass Transfer, 2007
- Experimental analysis of the effects of the operating variables on the performance of a single PEMFCEnergy Conversion and Management, 2007
- Simulation of the water and heat management in proton exchange membrane fuel cellsJournal of Power Sources, 2006
- Characterization of transport properties in gas diffusion layers for proton exchange membrane fuel cells: 1. Wettability (internal contact angle to water and surface energy of GDL fibers)Journal of Power Sources, 2006
- A two dimensional partial flooding model for PEMFCJournal of Power Sources, 2006
- Effective diffusivity and water-saturation distribution in single- and two-layer PEMFC diffusion mediumInternational Journal of Heat and Mass Transfer, 2003