Microwave dielectric heating of drops in microfluidic devices
- 19 March 2009
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 9 (12), 1701-1706
- https://doi.org/10.1039/b822357b
Abstract
We present a technique to locally and rapidly heat water drops in microfluidic devices with microwave dielectric heating. Water absorbs microwave power more efficiently than polymers, glass, and oils due to its permanent molecular dipole moment that has large dielectric loss at GHz frequencies. The relevant heat capacity of the system is a single thermally isolated picolitre-scale drop of water, enabling very fast thermal cycling. We demonstrate microwave dielectric heating in a microfluidic device that integrates a flow-focusing drop maker, drop splitters, and metal electrodes to locally deliver microwave power from an inexpensive, commercially available 3.0 GHz source and amplifier. The temperature change of the drops is measured by observing the temperature dependent fluorescence intensity of cadmium selenide nanocrystals suspended in the water drops. We demonstrate characteristic heating times as short as 15 ms to steady-state temperature changes as large as 30 °C above the base temperature of the microfluidic device. Many common biological and chemical applications require rapid and local control of temperature and can benefit from this new technique.Keywords
This publication has 23 references indexed in Scilit:
- FLASH: A rapid method for prototyping paper-based microfluidic devicesLab on a Chip, 2008
- Integrated circuit/microfluidic chip to programmably trap and move cells and droplets with dielectrophoresisLab on a Chip, 2007
- Microwave power absorption in low-reflectance, complex, lossy transmission linesJournal of Research of the National Institute of Standards and Technology, 2007
- Microfluidic diagnostic technologies for global public healthNature, 2006
- Thermal management in microfluidics using micro-Peltier junctionsApplied Physics Letters, 2005
- Two-phase flow in high-heat-flux micro-channel heat sink for refrigeration cooling applications: Part I––pressure drop characteristicsInternational Journal of Heat and Mass Transfer, 2005
- Engineering Flows in Small Devices: Microfluidics Toward a Lab-on-a-ChipAnnual Review of Fluid Mechanics, 2004
- Soft Lithography in Biology and BiochemistryAnnual Review of Biomedical Engineering, 2001
- Monolithic integrated microfluidic DNA amplification and capillary electrophoresis analysis systemSensors and Actuators B: Chemical, 2000
- High Speed Polymerase Chain Reaction in Constant FlowBioscience, Biotechnology, and Biochemistry, 1994