Radiative characteristics of regional hazes dominated by smoke from biomass burning in Brazil: Closure tests and direct radiative forcing
Open Access
- 27 December 1998
- journal article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research: Solid Earth
- Vol. 103 (D24), 31925-31941
- https://doi.org/10.1029/97jd03677
Abstract
Ground‐based Sun photometer measurements, and airborne measurements of the physical and optical properties of regional hazes dominated by smoke from biomass burning in Brazil, are used for aerosol radiative vertical column and local radiative closure tests. Optical depths at midvisible wavelengths of up to 2.5 measured by two independent methods (ground‐based Sun photometers and airborne measurements of the vertical profiles of aerosol optical extinction to the top of the smoke layer) agreed, on average, to within ∼20%. Local aerosol closure tests were carried out using in situ measurements of particle size distributions as inputs to a computational model of the aerosol. Calculated aerosol masses, aerosol absorption and scattering coefficients, and the amounts of solar radiation backscattered by the aerosol were generally within 25% of the measured values. The computational model was used to calculate a broader range of radiative transfer parameters, including aerosol mass scattering and absorption efficiencies, the asymmetry parameter, and upscatter fraction, across the solar spectrum. Regional values of direct aerosol radiative forcing produced by smoke aerosol in the cerrado and primary forest areas of Brazil are derived using the radiative transfer parameters as inputs to a radiative transfer model. The resulting net direct radiative forcing can result in either a cooling or a heating depending on the underlying surface albedo. Over a typical tropical forest the change in the daily average net shortwave flux per unit optical depth (at a wavelength of 550 nm) is −20 ± 7 W m−2 (where a negative value indicates cooling). Over the cerrado the forcing is −8± 9 W m−2, while over a dark surface, such as the ocean, the forcing is −26±6 W m−2. Over a reflective surface, such as a desert, we calculate a positive (heating) forcing of +25±12 W m−2.Keywords
This publication has 36 references indexed in Scilit:
- Humidification factors of aerosols from biomass burning in BrazilJournal of Geophysical Research: Solid Earth, 1998
- Sphericity and morphology of smoke particles from biomass burning in BrazilJournal of Geophysical Research: Solid Earth, 1998
- Single‐scattering albedo of smoke retrieved from the sky radiance and solar transmittance measured from groundJournal of Geophysical Research: Solid Earth, 1998
- Physical, chemical, and optical properties of regional hazes dominated by smoke in BrazilJournal of Geophysical Research: Solid Earth, 1998
- Aerosol climate effects: Local radiative forcing and column closure experimentsJournal of Geophysical Research: Solid Earth, 1997
- Fine mode aerosol composition at three long‐term atmospheric monitoring sites in the Amazon BasinJournal of Geophysical Research: Solid Earth, 1994
- Radiatively driven dynamics of the plume from 1991 Kuwait oil firesJournal of Geophysical Research: Solid Earth, 1994
- Influence of plumes from biomass burning on atmospheric chemistry over the equatorial and tropical South Atlantic during CITE 3Journal of Geophysical Research: Solid Earth, 1994
- Optical and thermal measurements of black carbon aerosol content in different environments: Variation of the specific attenuation cross-section, sigma (σ)Atmospheric Environment. Part A. General Topics, 1993
- Absorption characteristics of forest fire particulate matterAtmospheric Environment (1967), 1984