Drilling tool geometry evaluation for reinforced composite laminates
- 30 June 2010
- journal article
- Published by Elsevier BV in Composite Structures
- Vol. 92 (7), 1545-1550
- https://doi.org/10.1016/j.compstruct.2009.10.035
Abstract
No abstract availableKeywords
This publication has 22 references indexed in Scilit:
- Effects of special drill bits on drilling-induced delamination of composite materialsInternational Journal of Machine Tools and Manufacture, 2006
- Critical thrust force at delamination propagation during drilling of angle-ply laminatesComposite Structures, 2005
- Effect of eccentricity of twist drill and candle stick drill on delamination in drilling composite materialsInternational Journal of Machine Tools and Manufacture, 2005
- Taguchi analysis of delamination associated with various drill bits in drilling of composite materialInternational Journal of Machine Tools and Manufacture, 2004
- The effect of chisel length and associated pilot hole on delamination when drilling composite materialsInternational Journal of Machine Tools and Manufacture, 2003
- Drilling of composite structuresComposite Structures, 2001
- Machining parameters for an intelligent machining system for composite laminatesInternational Journal of Machine Tools and Manufacture, 2000
- Effects of hole machining defects on strength and fatigue life of composite laminatesComposites Part A: Applied Science and Manufacturing, 1997
- Some experimental investigations in the drilling of carbon fiber-reinforced plastic (CFRP) composite laminatesInternational Journal of Machine Tools and Manufacture, 1997
- Delamination During Drilling in Composite LaminatesJournal of Engineering for Industry, 1990