In Situ Generation of Hydrofluoric Acid during Microwave Digestion of Atmospheric Particulate Matter Prior to Trace Element Analysis Using Inductively Coupled Plasma Mass Spectrometry
- 1 November 2003
- journal article
- research article
- Published by Mary Ann Liebert Inc in Environmental Engineering Science
- Vol. 20 (6), 517-531
- https://doi.org/10.1089/109287503770736041
Abstract
Results from a systematic evaluation of numerous microwave-assisted digestion techniques to solubilize trace elements from ambient airborne particulate matter prior to analysis using inductively coupled-plasma mass spectroscopy (ICP-MS) are reported. Direct handling of HF was avoided by generating it in situ in closed Teflon-lined vessels during digestion by heating a mixture of NaF, HNO3, and the sample and later complexing any remaining HF using stoichiometric excess of boric acid. The effects of microwave digestion variables including dwell time (20–120 min), temperature (150–200°C), pressure (38–200 psig), acid type (HNO3 and HF), and absence or presence of peroxide on extraction efficiency were determined. Principal component analysis was conducted on the recoveries of 20 elements (Mg, Al, K, Ti, V, Cr, Mn, Fe, Ni, Co, Cu, Zn, As, Rb, Cd, Cs, Ba, La, Pb, and U) from urban particulate matter Standard Reference Material 1648, which revealed that the digestion matrix was the most important variable of all those experimentally investigated. Using H2O2 improved the clarity of the digested sample by ensuring complete oxidation of organic matter thereby facilitating subsequent ICP-MS analysis. Quantitative recoveries of Al, K, Ti, Rb, and La were possible only when using HNO3, NaF (HF), H3BO3, and H2O2, suggesting that these elements were associated with the siliceous matrix of urban airborne particulate matter even though this matrix increased detection limits compared to using HNO3 alone. Even though this method was not suitable for Cr recovery, it was found to extract significantly higher concentrations of Al, Mg, Ni, Co, and Ti from airborne line particulate matter samples obtained in Houston, TX, compared to X-ray fluorescence.Keywords
This publication has 13 references indexed in Scilit:
- Source Identification and Apportionment of Fine Particulate Matter in Houston, TX, Using Positive Matrix FactorizationEnvironmental Engineering Science, 2003
- Microwave assisted digestion of atmospheric aerosol samples followed by inductively coupled plasma mass spectrometry determination of trace elementsAnalytical and Bioanalytical Chemistry, 2001
- Chemical characterization of ambient aerosol collected during the southwest monsoon and intermonsoon seasons over the Arabian Sea: Labile‐Fe(II) and other trace metalsJournal of Geophysical Research: Atmospheres, 1999
- Microwave digestion of plant and grain standard reference materials in nitric and hydrofluoric acids for multi-elemental determination by inductively coupled plasma mass spectrometryJournal of Analytical Atomic Spectrometry, 1999
- Comparison of AAS, ICP-AES, PSA, and XRF in Determining Lead and Cadmium in SoilEnvironmental Science & Technology, 1995
- Measurement Methods to Determine Compliance with Ambient Air Quality Standards for Suspended ParticlesJournal of the Air & Waste Management Association, 1995
- Analytical procedures on multi-element determinations of airborne particles for receptor model useThe Analyst, 1995
- Microwave decomposition for airborne particulate matter for the determination of trace elements by inductively coupled plasma mass spectrometryThe Analyst, 1995
- An Association between Air Pollution and Mortality in Six U.S. CitiesNew England Journal of Medicine, 1993
- A Cyclone for Size-Selective Sampling of Ambient AirJournal of the Air Pollution Control Association, 1980